ELECTRICAL CHARACTERISTICS
Electrical Characteristics at IOUT = 0 mA, and TJ = +25°C unless otherwise specified.
Parameter
Device
Conditions
Min
Typ
Max
Units
Dropout Voltage
Note 2
Control Dropout
(VCONTROL - VOUT
AMS1510/-1.5/-2.5/
V
POWER =VOUT + 0.8V, ILOAD = 10mA
1.00
1.15
1.15
1.30
V
)
-2.85/-3.0/-3.3/-3.5/-5.0
VPOWER =VOUT + 0.8V, ILOAD = 10A
V
Power Dropout
(VPOWER - VOUT
AMS1510/-1.5/-2.5/
V
CONTROL =VOUT + 2.5V, ILOAD = 10mA
.10
.45
0.17
0.60
V
V
)
-2.85/-3.0/-3.3/-3.5/-5.0
VCONTROL =VOUT + 2.5V, ILOAD = 10A
Parameters identified with boldface type apply over the full operating temperature range.
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. For guaranteed specifications and test conditions, see the
Electrical Characteristics. The guaranteed specifications apply only for the test conditions listed.
Note 2: Unless otherwise specified VOUT = VSENSE. For the adjustable device VADJ = 0V.
Note 3: The dropout voltage for the AMS1510 is caused by either minimum control voltage or minimum power voltage. The specifications represent the
minimum input/output voltage required to maintain 1% regulation.
Note 4: For the adjustable device the minimum load current is the minimum current required to maintain regulation. Normally the current in the resistor
divider used to set the output voltage is selected to meet the minimum load current requirement.
Note 5: The control pin current is the drive current required for the output transistor. This current will track output current with a ratio of about 1:100. The
minimum value is equal to the quiescent current of the device.
PIN FUNCTIONS
Sense (Pin 1): This pin is the positive side of the reference
voltage for the device. With this pin it is possible to Kelvin
sense the output voltage at the load.
Output (Pin 3): This is the power output of the device.
VCONTROL (Pin 4): This pin is the supply pin for the
control circuitry of the device. The current flow into this
pin will be about 1% of the output current. The voltage
at this pin must be 1.3V or greater than the output
voltage for the device to regulate.
Adjust (Pin 2): This pin is the negative side of the
reference voltage for the device. Adding a small bypass
capacitor from the Adjust pin to ground improves the
transient response. For fixed voltage devices the Adjust pin
is also brought out to allow the user to add a bypass
capacitor.
VPOWER (Pin 5): This pin is the collector to the power
device of the AMS1510. The output load current is
supplied through this pin. The voltage at this pin must
be between 0.1V and 0.8V greater than the output
voltage for the device to regulate.
GND (Pin 2): For fixed voltage devices this is the bottom
of the resistor divider that sets the output voltage.
Advanced Monolithic Systems http://www.ams-semitech.com
AMS [ Advanced Monolithic Systems Ltd ]
