A29040D Series
Table 4. A29040D Command Definitions
Command
Sequence
(Note 1)
Bus Cycles (Notes 2 - 4)
Third Fourth
Addr Data Addr Data Addr Data Addr Data Addr Data Addr Data
RA RD
First
Second
Fifth
Sixth
Read (Notes 5, 6)
Reset (Note 6)
Manufacturer ID
1
1
4
4
4
XXX F0
555 AA
555 AA
555 AA
2AA 55
2AA 55
2AA 55
555
555
555
90
90
90
X00
X01
X03
37
86
Device ID
Autoselect
(Note 7)
Continuation ID
7F
00
SA
Sector Protect Verify
(Note 8)
4
555 AA
2AA 55
555
90
X02
01
Program
4
6
6
1
1
555 AA
555 AA
555 AA
XXX B0
XXX 30
2AA 55
2AA 55
2AA 55
555
555
555
A0
80
80
PA
555
555
PD
AA
AA
Chip Erase
Sector Erase
2AA 55
2AA 55
555
SA
10
30
Erase Suspend (Note 9)
Erase Resume (Note 10)
Legend:
X = Don't care
RA = Address of the memory location to be read.
RD = Data read from location RA during read operation.
PA = Address of the memory location to be programmed. Addresses latch on the falling edge of the
whichever happens later.
or
pulse,
CE
WE
PD = Data to be programmed at location PA. Data latches on the rising edge of
or
pulse, whichever happens first.
CE
WE
SA = Address of the sector to be verified (in autoselect mode) or erased. Address bits A18 - A16 select a unique sector.
Note:
1. See Table 1 for description of bus operations.
2. All values are in hexadecimal.
3. Except when reading array or autoselect data, all bus cycles are write operation.
4. Address bits A18 - A11 are don't cares for unlock and command cycles, unless SA or PA required.
5. No unlock or command cycles required when reading array data.
6. The Reset command is required to return to reading array data when device is in the autoselect mode, or if I/O5 goes high
(while the device is providing status data).
7. The fourth cycle of the autoselect command sequence is a read cycle.
8. The data is 00h for an unprotected sector and 01h for a protected sector. See "Autoselect Command Sequence" for more
information.
9. The system may read and program in non-erasing sectors, or enter the autoselect mode, when in the Erase Suspend mode.
10. The Erase Resume command is valid only during the Erase Suspend mode.
PRELIMINARY (June, 2016, Version 0.0)
10
AMIC Technology, Corp.
AMICC [ AMIC TECHNOLOGY ]
