A29002/A290021 Series
Write Operation Status
Several bits, I/O2, I/O3, I/O5, I/O6, and I/O7, are provided in
the A29002/A290021 to determine the status of a write
operation. Table 6 and the following subsections describe
the functions of these status bits. I/O7, I/O6 and I/O2 each
offer a method for determining whether a program or erase
operation is complete or in progress. These three bits are
discussed first.
START
Read I/O7-I/O0
Address = VA
I/O7:
Polling
Data
The
Polling bit, I/O7, indicates to the host system
Data
whether an Embedded Algorithm is in progress or
completed, or whether the device is in Erase Suspend.
Yes
I/O7 = Data ?
Polling is valid after the rising edge of the final
Data
pulse in the program or erase command sequence.
WE
During the Embedded Program algorithm, the device
outputs on I/O7 the complement of the datum programmed
to I/O7. This I/O7 status also applies to programming during
Erase Suspend. When the Embedded Program algorithm
is complete, the device outputs the datum programmed to
I/O7. The system must provide the program address to
read valid status information on I/O7. If a program address
No
I/O5 = 1?
Yes
No
falls within a protected sector,
Polling on I/O7 is
Data
active for approximately 2ms, then the device returns to
reading array data.
Read I/O7 - I/O0
Address = VA
During the Embedded Erase algorithm,
produces a "0" on I/O7. When the Embedded Erase
Polling
Data
algorithm is complete, or if the device enters the Erase
Suspend mode,
Polling produces a "1" on I/O7.This
Data
is analogous to the complement/true datum output
described for the Embedded Program algorithm: the erase
function changes all the bits in a sector to "1"; prior to this,
the device outputs the "complement," or "0." The system
must provide an address within any of the sectors selected
for erasure to read valid status information on I/O7.
Yes
I/O7 = Data ?
After an erase command sequence is written, if all sectors
No
selected for erasing are protected,
Polling on I/O7 is
Data
active for approximately 100ms, then the device returns to
reading array data. If not all selected sectors are protected,
the Embedded Erase algorithm erases the unprotected
sectors, and ignores the selected sectors that are
protected.
FAIL
PASS
When the system detects I/O7 has changed from the
complement to true data, it can read valid data at I/O7 - I/O0
on the following read cycles. This is because I/O7 may
change asynchronously with I/O0 - I/O6 while Output Enable
Note :
1. VA = Valid address for programming. During a sector
erase operation, a valid address is an address within any
sector selected for erasure. During chip erase, a valid
address is any non-protected sector address.
2. I/O7 should be rechecked even if I/O5 = "1" because
I/O7 may change simultaneously with I/O5.
(
) is asserted low. The
Polling Timings (During
Data
OE
Embedded Algorithms) figure in the "AC Characteristics"
section illustrates this. Table 6 shows the outputs for
Data
Polling algorithm.
Polling on I/O7. Figure 4 shows the
Data
Figure 4. Data Polling Algorithm
(February, 2002, Version 1.0)
12
AMIC Technology, Inc.
AMICC [ AMIC TECHNOLOGY ]
