A25L16P Series
POWER-UP AND POWER-DOWN
-
tPUW after VCC passed the VWI threshold
tVSL afterVCC passed the VCC(min) level
At Power-up and Power-down, the device must not be selected
S
(that is Chip Select ( ) must follow the voltage applied on VCC
)
These values are specified in Table 6.
until VCC reaches the correct value:
If the delay, tVSL, has elapsed, after VCC has risen above
VCC(min), the device can be selected for READ instructions
even if the tPUW delay is not yet fully elapsed.
V
CC (min) at Power-up, and then for a further delay of tVSL
VSS at Power-down
At Power-up, the device is in the following state:
S
Usually a simple pull-up resistor on Chip Select ( ) can be
used to insure safe and proper Power-up and Power-down.
To avoid data corruption and inadvertent write operations
during power up, a Power On Reset (POR) circuit is included.
The logic inside the device is held reset while VCC is less than
the POR threshold value, VWI – all operations are disabled, and
the device does not respond to any instruction.
The device is in the Standby mode (not the Deep
Power-down mode).
The Write Enable Latch (WEL) bit is reset.
Normal precautions must be taken for supply rail decoupling, to
stabilize the VCC feed. Each device in a system should have the
VCC rail decoupled by a suitable capacitor close to the package
pins. (Generally, this capacitor is of the order of 0.1µF).
At Power-down, when VCC drops from the operating voltage, to
below the POR threshold value, VWI, all operations are disabled
and the device does not respond to any instruction. (The
designer needs to be aware that if a Power-down occurs while
a Write, Program or Erase cycle is in progress, some data
corruption can result.)
Moreover, the device ignores all Write Enable (WREN), Page
Program (PP), Sector Erase (SE), Bulk Erase (BE) and Write
Status Register (WRSR) instructions until a time delay of tPUW
has elapsed after the moment that VCC rises above the VWI
threshold. However, the correct operation of the device is not
guaranteed if, by this time, VCC is still below VCC(min). No Write
Status Register, Program or Erase instructions should be sent
until the later of:
Figure 20. Power-up Timing
VCC
VCC(max)
VCC(min)
tPU
Full Device Access
time
PRELIMINARY (March, 2006, Version 0.2)
25
AMIC Technology Corp.