A25L16P Series
Read Status Register (RDSR)
The Read Status Register (RDSR) instruction allows the
Status Register to be read. The Status Register may be read
at any time, even while a Program, Erase or Write Status
Register cycle is in progress. When one of these cycles is in
progress, it is recommended to check the Write In Progress
(WIP) bit before sending a new instruction to the device. It is
also possible to read the Status Register continuously, as
shown in Figure 6.
status of the internal Write Enable Latch. When set to 1 the
internal Write Enable Latch is set, when set to 0 the internal
Write Enable Latch is reset and no Write Status Register,
Program or Erase instruction is accepted.
BP2, BP1, BP0 bits. The Block Protect (BP2, BP1, BP0) bits
are non-volatile. They define the size of the area to be
software protected against Program and Erase instructions.
These bits are written with the Write Status Register (WRSR)
instruction. When one or both of the Block Protect (BP2, BP1,
BP0) bits is set to 1, the relevant memory area (as defined in
Table 1.) becomes protected against Page Program (PP)
and Sector Erase (SE) instructions. The Block Protect (BP2,
BP1, BP0) bits can be written provided that the Hardware
Protected mode has not been set. The Bulk Erase (BE)
instruction is executed if, and only if, both Block Protect (BP2,
BP1, BP0) bits are 0.
Table 4. Status Register Format
b7
b0
SRWD
0
0
BP2 BP1 BP0 WEL WIP
Status Register
Write Protect
SRWD bit. The Status Register Write Disable (SRWD) bit is
Block Protect Bits
operated in conjunction with the Write Protect ( ) signal.
W
Write Enable Latch Bit
Write In Progress Bit
The Status Register Write Disable (SRWD) bit and Write
Protect (
) signal allow the device to be put in the
W
Hardware Protected mode (when the Status Register Write
The status and control bits of the Status Register are as
follows:
WIP bit. The Write In Progress (WIP) bit indicates whether
the memory is busy with a Write Status Register, Program or
Erase cycle. When set to 1, such a cycle is in progress, when
reset to 0 no such cycle is in progress.
Disable (SRWD) bit is set to 1, and Write Protect ( ) is
W
driven Low). In this mode, the non-volatile bits of the Status
Register (SRWD, BP2, BP1, BP0) become read-only bits and
the Write Status Register (WRSR) instruction is no longer
accepted for execution.
WEL bit. The Write Enable Latch (WEL) bit indicates the
Figure 6. Read Status Register (RDSR) Instruction Sequence and Data-Out Sequence
S
0
1
2
3
4
5
6
7
8
9 10 11 12
14 15
13
C
Instruction
DIO
Status Register Out
Status Register Out
High Impedance
DO
5
7
6
4
3
2
1
0
7
6
5
4
3
2
1
0
7
MSB
MSB
PRELIMINARY (April, 2007, Version 0.6)
11
AMIC Technology Corp.
AMICC [ AMIC TECHNOLOGY ]
