Analog Microelectronics, Inc.
AME811/AME811A/AME811R
3-1/2 Digit A/D Converter - Low Power
With HOLD And Differential Reference Inputs
Integration Status (INTEN)
The INTEN is an output signal of the converter, it is
“high” during the signal integration phase. This signal
can be used as a status indicator or a control to con-
nect the analog signal to the converter for processing.
It is available in 44 pin package.
Test
When the TEST is pulled to V+ all segments and the
minus sign will be activated. The TEST pin is tied to
the internally generated digital ground through a 500Ω
resistor in the AME811. It is typically 5V lower than V+.
TEST pin may be used as the negative power supply
for external CMOS logic at the maximum current of 1
mA.
De-integration Status (DEEN)
The DEEN is an output signal of the converter, it is
“high” during the reference de-integration phase. The
period of the DEEN is proportional to the conversion
result. Users may calculate the conversion result by
counting the number of clock pulse on the OSC3 pin
when DEEN is “high”. The conversion result is equal
to (N /4) - 1/2 where N is the number of the pulse at the
OSC3 pin. It is available in 44 pin package.
Data Hold
When the Hold pin is connected to V+ the conversion
result will not be updated. The conversion is still free
running during the hold mode.
n
Component Value Selection
Auto-Zero Capacitor (Caz)
The Caz capacitor size has some influence on system
noise. A 0.47µF capacitor is recommended for 200
mV full-scale applications. A 0.047µF capacitor is rec-
ommended for 2.0V full-scale applications. A mylar
dielectric capacitor is adequate.
Reference Capacitor (Cref)
A 0.1µF capacitor is acceptable when “INLO” is tied
to analog common. If a large common-mode voltage
exists and the application requires 200 mV full-scale,
increase Cref to 1.0
µF.
A mylar dielectric capacitor is
adequate.
10
AME [ ANALOG MICROELECTRONICS ]
