Revision 5.01 – November 30, 2005
S5335 – PCI Bus Controller, 3.3V
Data Sheet
Table 4. Address and Data Pins — PCI Local Bus
Signal
Type
Description
AD[31:00]
t/s
Local Bus Address/Data lines. Address and data are multiplexed on the same pins. Each bus opera-
tion consists of an address phase followed by one or more data phases. Address phases are identified
when the control signal, FRAME#, is asserted. Data transfers occur during those clock cycles in which
control signals IRDY# and TRDY# are both asserted.
C/BE[3:0]#
t/s
Bus Command and Byte Enables. These are multiplexed on the same pins. During the address phase
of a bus operation, these pins identify the bus command, as shown in the table below. During the data
phase of a bus operation, these pins are used as Byte Enables, with C/BE[0]# enabling byte 0 (least
significant byte) and C/BE[3]# enabling byte 3 (most significant byte).
C/BE[3:0]#
Description (during address phase)
Interrupt Acknowledge
0
0
0
0
0
0
0
0
1
1
1
1
1
1
1
1
0
0
0
0
1
1
1
1
0
0
0
0
1
1
1
1
0
0
1
1
0
0
1
1
0
0
1
1
0
0
1
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
Special Cycle
I/O READ
I/O WRITE
Reserved
Reserved
Memory Read
Memory Write
Reserved
Reserved
Configuration Read
Configuration Write
MEMORY READ - Multiple
Dual Address Cycle
Memory Read Line
Memory Write and Invalidate
PAR
t/s
Parity. This signal is even parity across the entire AD[31:00] field along with the C/BE[3:0]# field. The
parity is stable in the clock following the address phase and is sourced by the master. During the data
phase for write operations, the bus master sources this signal on the clock following IRDY# active;
during the data phase for read operations, this signal is sourced by the target and is valid on the clock
following TRDY# active. The PAR signal therefore has the same timing as AD[31:00}, delayed by one
clock.
AMCC Confidential and Proprietary
DS1657 20