Revision 1.26 – April 25, 2007
440EP – PPC440EP Embedded Processor
Data Sheet
Table 6. Signal Functional Description (Sheet 4 of 9)
Notes:
1. Receiver input has hysteresis
2. Must pull up (recommended value is 3kΩ to 3.3V)
3. Must pull down (recommended value is 1kΩ)
4. If not used, must pull up (recommended value is 3kΩ to 3.3V)
5. If not used, must pull down (recommended value is 1kΩ)
6. Strapping input during reset; pull-up or pull-down required
Signal Name
Description
I/O
Type
Notes
External Slave Peripheral Interface
Used by the PPC440EP to indicate that data transfers have
occurred.
DMAAck0:3
O
Multiplex
Used by slave peripherals to indicate they are prepared to
transfer data.
DMAReq0:3
I
Multiplex
Multiplex
1, 5
1, 3
1, 2
EOT0:3/TC0:3
PerAddr02:07
End Of Transfer/Terminal Count.
I/O
I/O
Peripheral address bus used by PPC440EP when not in
external master mode, otherwise used by external master.
3.3V LVTTL
Peripheral address bus used by PPC440EP when not in
external master mode, otherwise used by external master.
PerAddr08:31
I/O
3.3V LVTTL
Used by either the peripheral controller, DMA controller, or
external master to indicate the last transfer of a memory
access.
PerBLast
I/O
O
3.3V LVTTL
3.3V LVTTL
3.3V LVTTL
1, 4
2
PerCS0:5
External peripheral device select.
Peripheral data bus used by PPC440EP when not in external
master mode, otherwise used by external master.
PerData00:15
I/O
1
Note: PerData00 is the most significant bit (msb) on this bus.
Used by either peripheral controller or DMA controller
depending upon the type of transfer involved. When the
PPC440EP is the bus master, it enables the selected device to
drive the bus.
PerOE
O
I
3.3V LVTTL
3.3V LVTTL
2
Used by a peripheral slave to indicate it is ready to transfer
data.
PerReady
Used by the PPC440EP when not in external master mode, as
output by either the peripheral controller or DMA controller
depending upon the type of transfer involved. High indicates a
read from memory, low indicates a write to memory.
PerR/W
I/O
3.3V LVTTL
1, 2
Otherwise, it used by the external master as an input to
indicate the direction of transfer.
PerWBE0:1
PerErr
External peripheral data bus byte enables.
I/O
I/O
3.3V LVTTL
3.3V LVTTL
1, 2
1, 5
External Error. Used as an input to record external slave
peripheral errors.
AMCC Proprietary
53
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
