MAX 3000A Programmable Logic Device Family Data Sheet
MAX 3000A devices can be programmed in–system via an industry–
In–System
Programma-
bility
standard four–pin IEEE Std. 1149.1-1990 (JTAG) interface. In-system
programmability (ISP) offers quick, efficient iterations during design
development and debugging cycles. The MAX 3000A architecture
internally generates the high programming voltages required to program
its EEPROM cells, allowing in–system programming with only a single
3.3–V power supply. During in–system programming, the I/ O pins are
tri–stated and weakly pulled–up to eliminate board conflicts. The pull–up
value is nominally 50 kΩ.
MAX 3000A devices have an enhanced ISP algorithm for faster
programming. These devices also offer an ISP_Donebit that ensures safe
operation when in–system programming is interrupted. This ISP_Done
bit, which is the last bit programmed, prevents all I/ O pins from driving
until the bit is programmed.
ISP simplifies the manufacturing flow by allowing devices to be mounted
on a printed circuit board (PCB) with standard pick–and–place equipment
before they are programmed. MAX 3000A devices can be programmed by
downloading the information via in–circuit testers, embedded processors,
the MasterBlaster communications cable, the ByteBlasterMV parallel port
download cable, and the BitBlaster serial download cable. Programming
the devices after they are placed on the board eliminates lead damage on
high–pin–count packages (e.g., QFP packages) due to device handling.
MAX 3000A devices can be reprogrammed after a system has already
shipped to the field. For example, product upgrades can be performed in
the field via software or modem.
The Jam STAPL programming and test language can be used to program
MAX 3000A devices with in–circuit testers, PCs, or embedded processors.
For more information on using the Jam STAPL programming and test
language, see Application Note 88 (Using the Jam Language for ISP & ICR via
an Embedded Processor), Application Note 122 (Using Jam STAPL for ISP &
ICR via an Embedded Processor) and AN 111 (Embedded Programming Using
the 8051 and Jam Byte-Code).
f
The ISP circuitry in MAX 3000A devices is compliant with the IEEE Std.
1532 specification. The IEEE Std. 1532 is a standard developed to allow
concurrent ISP between multiple PLD vendors.
MAX 3000A devices can be programmed on Windows–based PCs with an
Altera Logic Programmer card, MPU, and the appropriate device adapter.
The MPU performs continuity checking to ensure adequate electrical
contact between the adapter and the device.
Programming
with External
Hardware
For more information, see the Altera Programming Hardware Data Sheet.
f
12
Altera Corporation
ALTERA [ ALTERA CORPORATION ]
