3–2
Chapter 3: JTAG and In-System Programmability
IEEE Std. 1149.1 (JTAG) Boundary-Scan Support
Table 3–1. MAX II JTAG Instructions (Part 2 of 2)
JTAG Instruction
CLAMP(1)
Instruction Code
Description
00 0000 1010
Places the 1-bit bypass register between the TDIand TDOpins,
which allows the boundary scan test data to pass synchronously
through selected devices to adjacent devices during normal device
operation, while holding I/O pins to a state defined by the data in the
boundary-scan register.
USER0
USER1
00 0000 1100
00 0000 1110
(2)
This instruction allows you to define the scan chain between TDI
and TDO in the MAX II logic array. This instruction is also used for
custom logic and JTAG interfaces.
This instruction allows you to define the scan chain between TDI
and TDOin the MAX II logic array. This instruction is also used for
custom logic and JTAG interfaces.
IEEE 1532
instructions
IEEE 1532 ISC instructions used when programming a MAX II device
via the JTAG port.
Notes to Table 3–1:
(1) HIGHZ, CLAMP, and EXTESTinstructions do not disable weak pull-up resistors or bus hold features.
(2) These instructions are shown in the 1532 BSDL files, which will be posted on the Altera® website at www.altera.com when they are available.
w
Unsupported JTAG instructions should not be issued to the MAX II device as this may
put the device into an unknown state, requiring a power cycle to recover device
operation.
The MAX II device instruction register length is 10 bits and the USERCODEregister
length is 32 bits. Table 3–2 and Table 3–3 show the boundary-scan register length and
device IDCODEinformation for MAX II devices.
Table 3–2. MAX II Boundary-Scan Register Length
Device
EPM240
Boundary-Scan Register Length
240
480
636
816
EPM570
EPM1270
EPM2210
Table 3–3. 32-Bit MAX II Device IDCODE (Part 1 of 2)
Binary IDCODE (32 Bits) (1)
Version
Manufacturer
LSB
Device
EPM240
(4 Bits)
Part Number
Identity (11 Bits)
(1 Bit) (2)
HEX IDCODE
0000
0010 0000 1010 0001
000 0110 1110
000 0110 1110
000 0110 1110
000 0110 1110
1
1
1
1
0x020A10DD
EPM240G
EPM570
0000
0000
0000
0010 0000 1010 0010
0010 0000 1010 0011
0010 0000 1010 0100
0x020A20DD
0x020A30DD
0x020A40DD
EPM570G
EPM1270
EPM1270G
EPM2210
EPM2210G
MAX II Device Handbook
© October 2008 Altera Corporation
ALTERA [ ALTERA CORPORATION ]
