Stratix Architecture
asynchronous preset load, synchronous clear, synchronous load, and
clock enable control for the register. These LAB-wide signals are available
in all LE modes. The addnsubcontrol signal is allowed in arithmetic
mode.
The Quartus II software, in conjunction with parameterized functions
such as library of parameterized modules (LPM) functions, automatically
chooses the appropriate mode for common functions such as counters,
adders, subtractors, and arithmetic functions. If required, you can also
create special-purpose functions that specify which LE operating mode to
use for optimal performance.
Normal Mode
The normal mode is suitable for general logic applications and
combinatorial functions. In normal mode, four data inputs from the LAB
local interconnect are inputs to a four-input LUT (see Figure 2–6). The
Quartus II Compiler automatically selects the carry-in or the data3
signal as one of the inputs to the LUT. Each LE can use LUT chain
connections to drive its combinatorial output directly to the next LE in the
LAB. Asynchronous load data for the register comes from the data3
input of the LE. LEs in normal mode support packed registers.
Figure 2–6. LE in Normal Mode
sload
sclear
aload
(LAB Wide) (LAB Wide)
(LAB Wide)
Register chain
connection
addnsub (LAB Wide)
ALD/PRE
(1)
Row, column, and
direct link routing
ADATA
D
Q
data1
data2
Row, column, and
direct link routing
ENA
CLRN
data3
cin (from cout
of previous LE)
4-Input
LUT
clock (LAB Wide)
Local routing
data4
ena (LAB Wide)
aclr (LAB Wide)
LUT chain
connection
Register
chain output
Register Feedback
Note to Figure 2–6:
(1) This signal is only allowed in normal mode if the LE is at the end of an adder/subtractor chain.
Altera Corporation
2–9
July 2005
Stratix Device Handbook, Volume 1
ALTERA [ ALTERA CORPORATION ]
