Chapter 7: User Flash Memory in MAX V Devices
7–25
Software Support for UFM Block
Opcodes
Table 7–10 lists the 8-bit instruction opcodes. After nCSis pulled low, the indicated
opcode must be provided. Otherwise, the interface assumes that the master device
has internal logic errors and ignores the rest of the incoming signals. When nCSis
pulled back to high, the interface is back to normal. nCSshould be pulled low again
for a new service request.
Table 7–10. Instruction Set for SPI
Name
Opcode
Operation
WREN
WRDI
RDSR
WRSR
READ
WRITE
00000110
00000100
00000101
00000001
00000011
00000010
00100000
01100000
Enable Write to UFM
Disable Write to UFM
Read Status Register
Write Status Register
Read data from UFM
Write data to UFM
Sector erase
SECTOR-ERASE
UFM-ERASE
Erase the entire UFM block (both sectors)
The READand WRITEopcodes are instructions for transmission, which means the data
will be read from or written to the UFM.
WREN, WRDI, RDSR, and WRSRare instructions for the status register, where they do not
have any direct interaction with UFM, but read or set the status register within the
interface logic. The status register provides status on whether the UFM block is
available for any READor WRITEoperation, whether the interface is WRITEenabled, and
the state of the UFM WRITEprotection. Table 7–11 lists the status register format. For
the read only implementation of ALTUFMSPI (Base or Extended mode), the status
register does not exist, saving LE resources.
Table 7–11. Status Register Format
Position
Bit 7
Status
Default at Power-Up
Description
X
X
0
0
0
0
0
0
—
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
—
X
—
X
—
BP1
BP0
Indicate the current level of block write protection (1)
Indicate the current level of block write protection (1)
1= SPI WRITEenabled state
Bit 1
Bit 0
WEN
0
0
0= SPI WRITE disabled state
1 = Busy, UFM WRITEor ERASEcycle in progress
0 = No UFM WRITEor ERASEcycle in progress
nRDY
Note to Table 7–11:
(1) For more information about status register bits BP1and BP0, refer to Table 7–12 and Table 7–13 on page 7–34
.
The following sections describe the instructions for SPI.
January 2011 Altera Corporation
MAX V Device Handbook
ALTERA [ ALTERA CORPORATION ]
