AS4C8M16S
T0
T1
T2
T3
T4
T5
T6
T7
T8
CLK
NOP
WRITE A
DIN A0
READ B
don’t care
don’t care
NOP
NOP
NOP
NOP
NOP
NOP
COMMAND
CAS# Latency=2
tCK2, DQ
DOUT B0
DOUT B1
DOUT B0
DOUT B2
DOUT B1
DOUT B3
DOUT B2
CAS# Latency=3
tCK3, DQ
don’t care
DIN A0
DOUT B3
Input data must be removed from the DQ at
least one clock cycle before the Read data
appears on the outputs to avoid data contention
Figure 12. Write Interrupted by a Read
(Burst Length = 4, CAS# Latency = 2, 3)
The BankPrecharge/PrechargeAll command that interrupts a write burst without the auto precharge
function should be issued m cycles after the clock edge in which the last data-in element is registered, where
m equals tWR/tCK rounded up to the next whole number. In addition, the DQM signals must be used to mask
input data, starting with the clock edge following the last data-in element and ending with the clock edge on
which the BankPrecharge/PrechargeAll command is entered (refer to the following figure).
T0
T1
T2
T3
T4
T5
T6
T7
CLK
DQM
tRP
WRITE
NOP
NOP
Precharge
Bank (s)
NOP
NOP
Activate
NOP
COMMAND
ADDRESS
DQ
Bank
Col n
ROW
tWR
DIN
n
DIN
N+1
Don’t Care
Note: The DQMs can remain low in this example if the length of the write burst is 1 or 2.
Figure 13. Write to Precharge
7
Write and AutoPrecharge command (RAS# = “H”, CAS# = “L”, WE# = “L”, Bas = Bank, A10 = “H”, A0-A8
= Column Address)
The Write and AutoPrecharge command performs the precharge operation automatically after the
write operation. Once this command is given, any subsequent command can not occur within a time
delay of {(burst length -1) + tWR + tRP (min.)}. At full-page burst, only the write operation is performed in
this command and the auto precharge function is ignored.
T0
T1
T2
T3
T4
T5
T6
T7
T8
T9
CLK
Bank A
Activate
Bank A
Activate
WRITE A
Auto Precharge
NOP
NOP
NOP
NOP
NOP
NOP
NOP
COMMAND
tDAL
DIN A0
DIN A1
DQ
tDAL=tWR+tRP
Begin AutoPrecharge
Bank can be reactivated at
completion of tDAL
Confidential
11
Rev. 2
Feb. /2014