[AK09915]
10.2.4.High-speed Mode (Hs-mode)
AK09915 supports the Hs-mode.
Hs-mode can only commence after the following conditions (all of which are in Fast/Standard-mode):
START condition (S)
8-bit master code (00001XXX)
not-acknowledge bit (Ā)
The diagram below shows data flow of the Hs-mode.
After start condition, feed master code 00001XXX for transfer to the Hs-mode. And then AK09915 feeds back
not-acknowledge bit and switch over to circuit for the Hs-mode between times t1 and tH. AK09915 can
communicate at the Hs-mode from next START condition. At time tFS, AK09915 switches its internal circuit
from the Hs-mode to the First mode with the STOP condition (P). This transfer completes in the bus free time
(tBUF).
Figure 10.12 Data transfer format in Hs-mode
Figure 10.13 Hs-mode transfer
015006484-E-02
2016/7
- 27 -