欢迎访问ic37.com |
会员登录 免费注册
发布采购

A4059MP8VR 参数 Datasheet PDF下载

A4059MP8VR图片预览
型号: A4059MP8VR
PDF下载: 下载PDF文件 查看货源
内容描述: [BATTERY MANAGEMENT STANDALONE LINEAR LI-ION BATTERY CHARGER]
分类和应用:
文件页数/大小: 12 页 / 317 K
品牌: AITSEMI [ AiT Semiconductor ]
 浏览型号A4059MP8VR的Datasheet PDF文件第1页浏览型号A4059MP8VR的Datasheet PDF文件第3页浏览型号A4059MP8VR的Datasheet PDF文件第4页浏览型号A4059MP8VR的Datasheet PDF文件第5页浏览型号A4059MP8VR的Datasheet PDF文件第6页浏览型号A4059MP8VR的Datasheet PDF文件第7页浏览型号A4059MP8VR的Datasheet PDF文件第8页浏览型号A4059MP8VR的Datasheet PDF文件第9页  
A4059  
BATTERY MANAGEMENT  
AiT Semiconductor Inc.  
www.ait-ic.com  
STANDALONE LINEAR LI-ION BATTERY CHARGER  
WITH THERMAL REGULATION  
PIN DESCRIPTION  
Top View  
Pin #  
1
Symbol  
TEMP  
Function  
The TEMP pin to the battery of the NTC sensor output. If the TEMP pin voltage is  
less than the input voltage of 30% or greater than 60% of the input voltage means  
the battery temperature is too low or too high, then the charge will be suspended. If  
the TEMP input voltage between 30% and 60%, then the battery fault condition will  
be cleared, the charge will continue. If you want to shield this feature ,you can  
connect the PIN to GND.  
Charge current programming, charge current monitoring and close pin. Charge  
current is controlled by a resistor of precision of 1% to the ground. In the constant  
charge current state, this port provides 1V voltage. In all conditions, this port  
charge current can be calculated using the following formula:  
IBAT = (VISET/RISET) ×1000  
ISET port can also be used to turn off the charger. Resistance to side with the  
separation of programming can pull the 3μA current source to increase ISET port  
voltage. When the suspension reached the limit voltage 1.21V, the device enters  
stop state, after charging the input current drop to 25μA. This port pinch-off voltage  
is about 2.4V. If supply this port voltage more than pinch-off voltage, the current  
will be 1.5mA. Through combination ISET pin to the ground, the charger will back  
to normal.  
2
ISET  
3
4
GND  
VIN  
Ground terminal .The EXPOSED pin is also connected with pin 3.  
Supply positive input voltage. Power supply for the charger. VCC can be 4.25V to  
6.5V and must have at least 1F bypass capacitor. If the BAT pin voltage of VCC  
down to within 30mV, A4052 into the suspension state, and make BAT Current  
less than 2A.  
REV1.0 - OCT 2013 RELEASED -  
- 2 -