42.0
24.8
9.53
12.0
(NOTE 1)
0.51
2.09
1
25.4
39.12
11.1
6.79
0.75
25.4
NOTE 1: MINIMUM DISTANCE FROM FRONT
OF CONNECTOR TO THE PANEL FACE.
Figure 8a. Recommended Common Mechanical Layout for SC and ST 1 x 9 Connectored Transceivers.
Regulatory Compliance
Electrostatic Discharge (ESD)
There are two design cases in
which immunity to ESD damage
is important.
These transceiver products are
intended to enable commercial
system designers to develop
equipment that complies with
the various international
regulations governing certifica-
tion of Information Technology
Equipment. See the Regulatory
Compliance Table for details.
Additional information is
available from your Agilent sales
representative.
The second case to consider is
static discharges to the exterior
of the equipment chassis con-
taining the transceiver parts. To
the extent that the duplex SC
connector is exposed to the
outside of the equipment chassis
it may be subject to whatever
ESD system level test criteria
that the equipment is intended
to meet.
The first case is during handling
of the transceiver prior to
mounting it on the circuit board.
It is important to use normal
ESD handling precautions for
ESD sensitive devices. These
precautions include using
grounded wrist straps, work
benches, and floor mats in ESD
controlled areas.
8
AGILENT [ AGILENT TECHNOLOGIES, LTD. ]
