1.0 INTRODUCTION
Table 1. Port 1 Alternate Functions
The UT69RH051 is a radiation-tolerant 8-bit microcontroller
that is pin equivalent to the MCS-51 industry standard
microcontroller when in a 40-pin DIP. The UT69RH051’s static
design allows operation from 1Hz to 20MHz. This data sheet
describes hardware and software interfaces to the UT69RH051.
Port
Pin
Alternate
Name
Alternate Function
P1.0
T2
External clock input to Timer/
Counter 2
P1.1
T2EX
Timer/Counter 2 Capture/Reload
trigger and direction control
2.0 SIGNAL DESCRIPTION
V
V
: +5V Supply voltage
: Circuit Ground
P1.2
P1.3
ECI
External count input to PCA
DD
SS
CEX0
External I/O for PCA capture/
compare Module 0
Port 0 (P0.0 - P0.7): Port 0 is an 8-bit port. Port 0 pins are used
as the low-order multiplexed address and data bus during
accesses to external program and data memory. Port 0 pins use
internal pullups when emitting 1’s and are TTL compatible.
P1.4
P1.5
P1.6
P1.7
CEX1
CEX2
CEX3
CEX4
External I/O for PCA capture/
compare Module 1
External I/O for PCA capture/
compare Module 2
Port 1 (P1.0 - P1.7): Port 1 is an 8-bit bidirectional I/O port with
internal pullups. The output buffers can drive TTL loads. When
the Port 1 pins have 1’s written to them, they are pulled high by
the internal pullups and can be used as inputs in this state. As
inputs, any pins that are externally pulled low sources current
because of the pullups. In addition, Port 1 pins have the alternate
uses shown in table 1.
External I/O for PCA capture/
compare Module 3
External I/O for PCA capture/
compare Module 4
Port 2 (P2.0 - P2.7): Port 2 is an 8-bit port. Port 2 pins are used
asthehigh-orderaddressbusduringaccessestoexternalProgram
Memory and during accesses to external Data Memory that uses
16-bit addresses (i.e., MOVX@DPTR). Port 2 uses internal
pullups when emitting 1’s in this mode. During operations that
do not require a 16-bit address, Port 2 emits the contents of the
P2 Special Function Registers (SFR). The pins have internal
pullups and drives TTL loads.
Table 2. Port 3 Alternate Functions
Port
Pin
Alternate
Name
Alternate Function
P3.0
P3.1
P3.2
P3.3
P3.4
P3.5
P3.6
RXD
TXD
INT0
INT1
T0
Serial port input
Serial port output
Port 3 (P3.0 - P3.7): Port 3 is an 8-bit bidirectional I/O port with
internal pullups. The output buffers can drive TTL loads. When
the Port 3 pins have 1’s written to them, they are pulled high by
the internal pullups and can be used as inputs in this state. As
inputs, any pins that are externally pulled low sources current
because of the pullups. In addition, Port 3 pins have the alternate
uses shown in table 2.
External interrupt 0
External interrupt 1
External clock input for Timer 0
External clock input for Timer 1
T1
WR
External Data Memory write
strobe
P3.7
RD
External Data Memory read strobe
2
AEROFLEX [ AEROFLEX CIRCUIT TECHNOLOGY ]
