AMS1505V
ELECTRICAL CHARACTERISTICS
Electrical Characteristics at IOUT = 0 mA, and TJ = +25°C unless otherwise specified.
Parameter
Device
Conditions
Min
Typ
Max
Units
Note 2
Dropout Voltage
Control Dropout
(VCONTROL - VOUT
AMS1505V/-1.5/-2.5/
-2.85/-3.0/-3.3/-3.5/-5.0
V
POWER =VOUT + 0.8V, ILOAD = 10mA
V
1.00
1.15
1.20
1.30
)
VPOWER =VOUT + 0.8V, ILOAD = 5A
V
Power Dropout
AMS1505V/-1.5/-2.5/
-2.85/-3.0/-3.3/-3.5/-5.0
V
CONTROL =VOUT + 2.5V, ILOAD = 3A
mV
mV
175
300
200
350
(VPOWER - VOUT
)
VCONTROL =VOUT + 2.5V, ILOAD = 5A
Parameters identified with boldface type apply over the full operating temperature range.
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. For guaranteed specifications and test conditions, see the
Electrical Characteristics. The guaranteed specifications apply only for the test conditions listed.
Note 2: Unless otherwise specified VOUT = VSENSE. For the adjustable device VADJ = 0V.
Note 3: The dropout voltage for the AMS1505V is caused by either minimum control voltage or minimum power voltage. The specifications represent the
minimum input/output voltage required to maintain within 1% regulation.
Note 4: For the adjustable device the minimum load current is the minimum current required to maintain regulation. Normally the current in the resistor
divider used to set the output voltage is selected to meet the minimum load current requirement.
Note 5: The control pin current is the drive current required for the output transistor. This current will track output current with a ratio of about 1:100. The
minimum value is equal to the quiescent current of the device.
PIN FUNCTIONS
Sense (Pin 1): This pin is the positive side of the reference
voltage for the device. With this pin it is possible to Kelvin
sense the output voltage at the load.
VCONTROL (Pin 4): This pin is the supply pin for the
control circuitry of the device. The current flow into
this pin will be about 1% of the output current. The
voltage at this pin must be 1.3V or greater than the
output voltage for the device to regulate.
Adjust/Ground (Pin 2): This pin is the negative side of
the reference voltage for the device. Adding a small
bypass capacitor from the Adjust pin to ground improves
the transient response.
VPOWER (Pin 5): This pin is the collector to the power
device of the AMS1505V. The output load current is
supplied through this pin. The voltage at this pin must
be between 0.1V and 0.35V greater than the output
voltage for the device to regulate.
Output (Pin 3): This is the power output of the device.
Advanced Monolithic Systems, Inc. www.advanced-monolithic.com Phone (925) 443-0722 Fax (925) 443-0723
ADMOS [ ADVANCED MONOLITHIC SYSTEMS ]
