ADuM1400/ADuM1401/ADuM1402
Data Sheet
For example, at a magnetic field frequency of 1 MHz, the
maximum allowable magnetic field of 0.2 kgauss induces a
voltage of 0.25 V at the receiving coil. This is about 50% of the
sensing threshold and does not cause a faulty output transition.
Similarly, if such an event occurs during a transmitted pulse
(and has the worst-case polarity), it reduces the received pulse
from >1.0 V to 0.75 V—still well above the 0.5 V sensing
threshold of the decoder.
POWER CONSUMPTION
The supply current at a given channel of the ADuM140x isolator
is a function of the supply voltage, the data rate of the channel,
and the output load of the channel.
For each input channel, the supply current is given by
I
I
DDI = IDDI (Q)
f ≤ 0.5 fr
f > 0.5 fr
DDI = IDDI (D) × (2f − fr) + IDDI (Q)
The preceding magnetic flux density values correspond to
specific current magnitudes at given distances from the
ADuM140x transformers. Figure 20 expresses these allowable
current magnitudes as a function of frequency for selected
distances. As shown, the ADuM140x is extremely immune
and can be affected only by extremely large currents operated
at high frequency very close to the component. For the 1 MHz
example noted, one would have to place a 0.5 kA current 5 mm
away from the ADuM140x to affect the operation of the
component.
For each output channel, the supply current is given by
I
I
DDO = IDDO (Q)
f ≤ 0.5 fr
DDO = (IDDO (D) + (0.5 × 10−3) × CL × VDDO) × (2f − fr) + IDDO (Q)
f > 0.5 fr
where:
DDI (D), IDDO (D) are the input and output dynamic supply currents
I
per channel (mA/Mbps).
CL is the output load capacitance (pF).
V
DDO is the output supply voltage (V).
1000
f is the input logic signal frequency (MHz); it is half of the input
data rate expressed in units of Mbps.
fr is the input stage refresh rate (Mbps).
DISTANCE = 1m
100
I
DDI (Q), IDDO (Q) are the specified input and output quiescent
supply currents (mA).
10
To calculate the total VDD1 and VDD2 supply current, the supply
currents for each input and output channel corresponding to
DISTANCE = 100mm
1
VDD1 and VDD2 are calculated and totaled. Figure 8 and Figure 9
DISTANCE = 5mm
provide per-channel supply currents as a function of data rate
for an unloaded output condition. Figure 10 provides per-
channel supply current as a function of data rate for a 15 pF
output condition. Figure 11 through Figure 15 provide total
0.1
0.01
1k
10k
100k
1M
10M
100M
V
DD1 and VDD2 supply current as a function of data rate for
ADuM1400/ADuM1401/ADuM1402 channel configurations.
MAGNETIC FIELD FREQUENCY (Hz)
Figure 20. Maximum Allowable Current
for Various Current-to-ADuM140x Spacings
Note that at combinations of strong magnetic field and high
frequency, any loops formed by printed circuit board traces
could induce error voltages sufficiently large enough to trigger
the thresholds of succeeding circuitry. Care should be taken in
the layout of such traces to avoid this possibility.
Rev. H | Page 28 of 32