ADuM1200/ADuM1201
1000
POWER CONSUMPTION
DISTANCE = 1m
The supply current at a given channel of the ADuM120x
isolator is a function of the supply voltage, the channel’s data
rate, and the channel’s output load.
100
10
For each input channel, the supply current is given by
DISTANCE = 100mm
1
I
DDI = IDDI (Q)
IDDI = IDDI (D) × (2f – fr) + IDDI (Q)
for each output channel, the supply current is given by
IDDO = IDDO (Q) f ≤ 0.5fr
f ≤ 0.5fr
DISTANCE = 5mm
f > 0.5fr
0.1
0.01
1k
10k
100k
1M
10M
100M
MAGNETIC FIELD FREQUENCY (Hz)
I
DDO = (IDDO (D) + (0.5 × 10−3) × CLVDDO) × (2f – fr) + IDDO (Q)
f > 0.5fr
Figure 14. Maximum Allowable Current for Various
Current-to-ADuM120x Spacings
where:
Note that at combinations of strong magnetic fields and high
frequencies, any loops formed by printed circuit board traces
could induce sufficiently large error voltages to trigger the
threshold of succeeding circuitry. Care should be taken in the
layout of such traces to avoid this possibility.
I
DDI (D), IDDO (D) are the input and output dynamic supply currents
per channel (mA/Mbps).
CL is the output load capacitance (pF).
V
DDO is the output supply voltage (V).
f is the input logic signal frequency (MHz, half of the input data
rate, NRZ signaling).
fr is the input stage refresh rate (Mbps).
I
DDI (Q), IDDO (Q) are the specified input and output quiescent
supply currents (mA).
To calculate the total IDD1 and IDD2 supply current, the supply
currents for each input and output channel corresponding to
IDD1 and IDD2 are calculated and totaled. Figure 6 and Figure 7
provide per-channel supply currents as a function of data rate
for an unloaded output condition. Figure 8 provides per-
channel supply current as a function of data rate for a 15 pF
output condition. Figure 9 through Figure 11 provide total IDD1
and IDD2 supply current as a function of data rate for
ADuM1200 and ADuM1201 channel configurations.
Rev. B | Page 16 of 20
ADI [ ADI ]
