欢迎访问ic37.com |
会员登录 免费注册
发布采购

ADE7761ARS-REF 参数 Datasheet PDF下载

ADE7761ARS-REF图片预览
型号: ADE7761ARS-REF
PDF下载: 下载PDF文件 查看货源
内容描述: 电能计量IC ,带有片上故障和中性丢失检测 [Energy Metering IC with On-Chip Fault and Missing Neutral Detection]
分类和应用: 模拟IC信号电路光电二极管
文件页数/大小: 28 页 / 321 K
品牌: ADI [ ADI ]
 浏览型号ADE7761ARS-REF的Datasheet PDF文件第6页浏览型号ADE7761ARS-REF的Datasheet PDF文件第7页浏览型号ADE7761ARS-REF的Datasheet PDF文件第8页浏览型号ADE7761ARS-REF的Datasheet PDF文件第9页浏览型号ADE7761ARS-REF的Datasheet PDF文件第11页浏览型号ADE7761ARS-REF的Datasheet PDF文件第12页浏览型号ADE7761ARS-REF的Datasheet PDF文件第13页浏览型号ADE7761ARS-REF的Datasheet PDF文件第14页  
ADE7761  
Pin No.  
Mnemonic  
Description  
13  
14  
INT  
RCLKIN  
This pin is internally used and should be connected to DGND.  
To enable the internal oscillator as a clock source on the chip, a precise low temperature drift resistor at  
nominal value of 6.2 kΩ must be connected from this pin to DGND.  
15  
FAULT  
This logic output goes active high when a fault or missing neutral condition occurs. A fault is defined as  
a condition under which the signals on V1A and V1B differ by more than 6.25%. A missing neutral  
condition is defined when the chip is powered up with no voltage at the input. The logic output is reset  
to zero when a fault or missing neutral condition is no longer detected. See the Fault Detection section  
and the Missing Neutral Mode section.  
16  
17  
REVP  
This logic output goes logic high when negative power is detected, that is, when the phase angle  
between the voltage and current signals is greater than 90°. This output is not latched and is reset when  
positive power is once again detected. The output goes high or low at the same time as a pulse is issued  
on CF.  
This pin provides the ground reference for the digital circuitry in the ADE7761, that is, multiplier, filters,  
and digital-to-frequency converter. This pin should be tied to the digital ground plane of the PCB. The  
digital ground plane is the ground reference for all digital circuitry such as counters (mechanical and  
digital), MCUs, and indicator LEDs. For good noise suppression, the analog ground plane should be  
connected only to the digital ground plane at the DGND pin.  
DGND  
18  
CF  
Calibration Frequency Logic Output. The CF logic output, active high, gives instantaneous active power  
information. This output is intended to be used for operational and calibration purposes. See the Digital-  
to-Frequency Conversion section.  
19, 20  
F2, F1  
Low Frequency Logic Outputs. F1 and F2 supply average active power information. The logic outputs  
can be used to directly drive electromechanical counters and 2-phase stepper motors.  
Rev. A | Page 10 of 28