AD8044
Active Filters
Layout Considerations
Active filters at higher frequencies require wider bandwidth op
amps to work effectively. Excessive phase shift produced by
lower frequency op amps can significantly impact active filter
performance.
The specified high speed performance of the AD8044 requires
careful attention to board layout and component selection.
Proper RF design techniques and low-pass parasitic component
selection are necessary.
Figure 38 shows an example of a 2 MHz biquad bandwidth
filter that uses three op amps of an AD8044 package. Such
circuits are sometimes used in medical ultrasound systems to
lower the noise bandwidth of the analog signal before A/D
conversion.
The PCB should have a ground plane covering all unused por-
tions of the component side of the board to provide a low im-
pedance path. The ground plane should be removed from the
area near the input pins to reduce the stray capacitance.
Chip capacitors should be used for the supply bypassing. One
end should be connected to the ground plane and the other
within 1/8 inch of each power pin. An additional large (0.47 µF
– 10 µF) tantalum electrolytic capacitor should be connected in
parallel, but not necessarily so close, to supply current for fast,
large signal changes at the output.
R6
1k⍀
C1
50pF
R2
2k⍀
R4
2k⍀
C2
50pF
R1
3k⍀
The feedback resistor should be located close to the inverting
input pin in order to keep the stray capacitance at this node to a
minimum. Capacitance variations of less than 1 pF at the in-
verting input will significantly affect high speed performance.
R3
2k⍀
2
3
V
IN
R5
2k⍀
1
6
5
7
9
8
V
OUT
AD8044
10
AD8044
AD8044
Stripline design techniques should be used for long signal traces
(greater than about 1 inch). These should be designed with a
characteristic impedance of 50 Ω or 75 Ω and be properly termi-
nated at each end.
Figure 38. 2 MHz Biquad Bandpass Filter Using AD8044
The frequency response of the circuit is shown in Figure 39.
0
–10
–20
–30
–40
10k
100k
1M
10M
100M
FREQUENCY – Hz
Figure 39. Frequency Response of 2 MHz Bandpass
Biquad Filter
–13–
REV. A
ADI [ ADI ]
