1.3 Absolute maximum ratings. 1/
Supply voltage (V ) ................................................................................................... 7.5 V
S
Input voltage (SIG –IN and SIG +IN pins to CKT COM pin) ...................................... -3.0 V to +300 mV
Attenuator input voltage (ATN IN pin to ATN COM pins) ........................................... 3.0 V
Storage temperature range ....................................................................................... -65C to +150C
Lead temperature (soldering, 60 seconds) ................................................................ +300C
Thermal resistance, junction-to-case (JC) ................................................................ See MIL-STD-1835
Thermal resistance, junction-to-ambient (JA) ........................................................... 95C/W
1.4 Recommended operating conditions.
Supply voltage range (V ) ......................................................................................... 4.5 V to 7.5 V
S
Ambient operating temperature range (T ) ............................................................... -55C to +125C
A
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883
-
Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://quicksearch.dla.mil or from the Standardization Document Order
Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
______
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
SIZE
STANDARD
5962-90955
A
MICROCIRCUIT DRAWING
DLA LAND AND MARITIME
REVISION LEVEL
D
SHEET
COLUMBUS, OHIO 43218-3990
3
DSCC FORM 2234
APR 97