3B17
Voltage
1 V rms to 5 V rms
Voltage, tolerance
Frequency
±10%
1 kHz to 10 kHz, ±15%
Drive
20 mA rms, minimum
Harmonic Distortion
< 0.5%
Voltage Output Calibration4
Span Adjustment Range
Zero Adjustment Range
256:1
±5 V
Current Output Calibration4
±5% of Span
Zero and Span Adjustment Range
Input Bias Current
+1 µA
Input Resistance
100 MΩ
Bandwidth5, -3 dB
100 Hz
Output Rise Time, 10% to 90% Span
5 ms
Input Protection, Signal and Excitation Voltage
130 V rms maximum
ANSI/IEEE C37.90.1-1989
Continuous Short to Ground
130 V rms, continuous
Continuous
Transient
Voltage Output Protection
Current Output Protection
±15 V dc Supplies
Rated Operation
Current
±(13 V dc to 18 V dc)
±65 mA plus LVDT Current7
±0.03% span/V
Sensitivity
+24 V dc Loop Supply
Rated Operation
Current
+13.5 V dc to +30 V dc
+27 mA @ lout = 20 mA
±0.001% span/V
Sensitivity
Mechanical Dimensions
3.15" x 3.395" x 0.775"
80.0 mm x 86.2 mm x 19.7 mm)
Environmental
Temperature Range
Rated Performance
Storage
-25°C to +85°C
-55°C to +85°C
Relative Humidity, 24 hours
RFI Susceptibility
0 to 95% @ +60°C non-condensing
±0.5% Span error @ 400 MHz, 5 Watt, 3 ft
1 For a 0 mA to 20 mA range, a typical minimum output current is 10 µA.
2 Includes the combined effects of repeatability, hysteresis, and nonlinearity.
3 With respect to the voltage output.
4 A wide range of custom zero suppression and span is available with the 3B17-00 model, using the AC1310 ranging card.
5 Bandwidth can be set for up to 1/10 the excitation frequency when ordering Model 3B17-custom.
6 +24 V dc loop power is required for driving the current output at loads up to 850Ω. If a current output load of 400Ω or less is applied, +15 V dc is sufficient for loop power. If only
voltage output is used, loop power is not required.
7 Typical supply current is ±40 mA per module plus ±5 mA for the LVDT drive current. To calculate supply current requirements from LVDT currents, use 75% of the LVDT rms
current.
Specifications subject to change without notice.
Rev. 0 | Page 4 of 8
ADI [ ADI ]
