PAC5210
Power Application Controller
12.3.2. Power Drivers Control
All power drivers are initially disabled from power-on-reset. To enable the power drivers, the microprocessor
must first set the driver enable bit to '1'. The OMx open-drain drivers are controlled by their corresponding
register bits. Refer to the PAC application notes and user guide for additional information on power drivers
control programming.
12.3.3. Gate Driver Fault Protection
The ENHS1 (protection group 1 control output) and ENHS2 (protection group 2 control output) pins are provided
for enabling external power drivers with fault protection.
- 40 -
Rev 1.11‒May 3, 2017