ACT8740
Rev PrB, 25-Feb-08
LOW-NOISE, LOW-DROPOUT, LINEAR REGULATORS
ELECTRICAL CHARACTERISTICS
(VINL = 3.6V, COUT3 = 1µF, TA = 25°C, unless otherwise specified.)
PARAMETER
INL Operating Voltage Range
INL UVLO Threshold
TEST CONDITIONS
MIN
3.1
TYP
MAX UNIT
5.5
3.1
V
V
V
V
INL Input Rising
INL Input Falling
2.9
3
UVLO Hysteresis
V
0.1
c
TA = 25°C
-1.2
-2.5
VNOM3
VNOM3
0
+2
+3
Output Voltage Accuracy
%
TA = -40°C to 85°C
Line Regulation Error
Load Regulation Error
VINL = Max(VOUT3 + 0.5V, 3.6V) to 5.5V
mV
I
OUT3 = 1mA to 350mA
-0.004
70
%/mA
f = 1kHz, IOUT3 = 350mA, COUT3 = 1µF
f = 10kHz, IOUT3 = 350mA, COUT3 = 1µF
Regulator Enabled
Power Supply Rejection Ratio
dB
60
40
Supply Current per Output
µA
mV
mA
Regulator Disabled
0
Dropout Voltaged
IOUT3 = 160mA, VOUT3 > 3.1V
100
200
350
Output Current
Current Limite
VOUT3 = 95% of regulation voltage
400
Internal Soft-Start
100
89
µs
%
Power Good Flag High Threshold
Output Noise
VOUT3, hysteresis = -4%
COUT3 = 10µF, f = 10Hz to 100kHz
40
µVRMS
µF
Stable COUT3 Range
Discharge Resistor in Shutdown
1
20
LDO Disabled, DIS3[ ] = [1]
650
ꢀ
c: VNOM3 refers to the nominal output voltage level for VOUT3 as defined by the Ordering Information section.
d: Dropout Voltage is defined as the differential voltage between input and output when the output voltage drops 100mV below the
regulation voltage at 1V differential voltage.
e: LDO current limit is defined as the output current at which the output voltage drops to 95% of the respective regulation voltage.
Under heavy overload conditions the output current limit folds back by 30% (typ)
Innovative Products. Active Solutions.
- 26 -
www.active-semi.com
ActivePMUTM is a trademark of Active-Semi.
Copyright © 2008 Active-Semi, Inc.
I2CTM is a trademark of Philips Electronics.