SERIES 134
SCHEMATIC DIAGRAMS
OUTLINE DIMENSIONS
CASE DETAIL
.375 (9.53)
SQ. MAX.
TERMINAL LOCATIONS
(Viewed from Terminals; Numbers for Reference Only)
.031 .003
(.79 .08)
.335 (8.51)
SQ. MAX.
.035 .010
(.89 .25)
134
8
4
.375 (9.53) MAX.
7
1
.100 .010
(2.54 .25)
TYP 8 PLACES
6
5
2
3
WIRE LEAD .750 (19.05) MIN.
PIN: .187 (1.75) .010 (.25)
(See Note 5)
DIMENSIONS ARE SHOWN IN INCHES (MILLIMETERS)
+.002 (.05)
–.001 (.03)
.017 (.43)
DIA.
134D
GENERAL NOTES
1. Relay contacts will exhibit no chatter in excess of 10 μsec or transfer in excess of 1 μsec.
2. “Typical” characteristics are based on available data and are best estimates. No on-going
verification tests are performed.
3. Unless otherwise specified, parameters are initial values.
4. For reference only. Coil resistance not directly measurable at relay terminals due to
internal series diode in 134DD only.
134DD
5. Unless otherwise specified, relays will be supplied with either gold-plated or solder-
coated leads.
6. The slash and characters appearing after the slash are not marked on the relay.
7. Screened HI-REL versions available. Contact factory.
8.
SCHEMATICS ARE VIEWED
FROM TERMINALS
2
®
Teledyne Part Numbering System for T R Established Reliability Relay
ER 134
Z
M4 - 26 A / S Q
Q= Solder-Coated Leads
G= Gold-Plated Leads
(Notes 5 and 6)
Estab
lished Reli
ability
Designator
Relay Series
S= .187" leads
(Note 6)
Ground Pin Option
(See Appendix)
Screening and Reliability
Level
Pad Option
(See Appendix)
Coil Voltage
Teledyne Part Numbering System for Military Qualified (JAN) Relays
134 M4 - 26
J
Z
P
L
Militar
y (JAN)
Screening and Reliability
Level
Designator
Relay Series
Ground Pin Option
(See Appendix)
Terminal Variant
P = 0.187"
Coil Voltage
Pad Option
(See Appendix)
134 Page 3
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
www.teledynerelays.com
©2004 TELEDYNE RELAYS
134/0704/Q1
TELEDYNE [ TELEDYNE TECHNOLOGIES INCORPORATED ]
