C-TYPE Data Sheet
Performance Characteristics
Table 1. Electrical Performance, 5V option
Parameter
Symbol
Min
0.012
4.5
Typical
Maximum
125.000
5.5
Units
MHz
V
V
mA
Frequency
fO
VDD
1
Operating Supply Voltage
Absolute Maximum Supply Voltage
Supply Current, Output Enabled
<1.5 MHz
5.0
-0.7
7.0
IDD
7
1.5 to 20 MHz
20.01 to 50 MHz
50.01 to 85 MHz
85.01 to 125 MHz
10
30
50
60
30
Supply Current, Out disabled
Output Logic Levels
IDD
uA
Output Logic High2
VOH
VOL
IOH
IOL
tR/tF
0.9*VDD
V
V
mA
mA
ns
Output Logic Low2
0.1*VDD
Output Logic High Drive
Output Logic Low Drive
Output Rise/Fall Time2
< 1.00 MHz
16
16
200
8
1.0 to 20.00 MHz
20.01 to 50.00 MHz
5
50.01 to 125.00 MHz
Duty Cycle3 (ordering option)
Operating Temperature (ordering option)
Storage Temperature
Stability4 (ordering option)
RMS Jitter, 12kHz to 20 MHz
Period Jitter, RMS
2
SYM
45/55
-10/70 or -40/85
%
°C
°C
ppm
ps
-55
125
±20, ±25, ±32, ±50, ±100
0.5
2.5
1
ps
V
Output Enable/Disable5
Output Enabled
4.0
Output Disabled
0.8
10
Internal Enable Pull-Up resistor5
Start-up time
100
Kohm
ms
1. A 0.01uF and a 0.1uF capacitor should be located as close to the supply as possible (to ground) is recommended.
2. Figure 1 defines these parameters. Figure 2 illustrates the operating conditions under which these parameters are tested and
specified.
3. Symmetry is measured defined as On Time/Period.
4. Includes calibration tolerance, operating temperature, supply voltage variations, aging and shock and vibration (not under
operation).
5. Output will be enabled if enable/disable is left open.
tR
tF
IDD
VOH
50%
VOL
4
1
+
-
3
.1mF
.01mF
2
VDD
IC
V C
On Time
15pF
+
-
Period
Figure 1. Output Waveform
Figure 2. Typical Output Test Conditions (25±5°C)
Vectron International 267 Lowell Rd, Hudson NH 03051 Tel: 1-88-VECTRON-1
e-mail: vectron@vectron.com
VECTRON [ Vectron International, Inc ]
