TS16G~64GCF400
400X CompactFlash Card
ꢁ
Input Leakage Current
Note: In Table 1 below, x refers to the characteristics described in table 2. For example, I1U indicates a pull-up resistor with a type 1
input characteristic.
Table 1: Input Leakage Current
Type
IxZ
Parameter
Symbol
IL
Conditions
Vih = Vcc / Vil = Gnd
Vcc = 5.0V
MIN TYP MAX Units
Input Leakage Current
Pull-Up Resistor
-1
1
µA
IxU
RPU1
RPD1
50k
50k
500k
500k
Ohm
Ohm
IxD
Pull-Down Resistor
Vcc = 5.0V
Note: The minimum pull-up resistor resistance meets the PCMCIA PC Card specification of 10k ohms but is intentionally higher in the
CompactFlash Specification to reduce power use.
ꢁ
Input Characteristics
Table 2: Input Characteristics
Type
Parameter
Symbol
Units
MIN
TYP
MAX
MIN
TYP
MAX
VCC = 3.3 V
VCC = 5.0 V
Volts
Volts
Volts
Input Voltage
CMOS
Vih
Vil
1
2
2.4
1.5
0.6
0.6
4.0 1
2.0
0.8
0.8
Input Voltage
CMOS
Vih
Vil
Input Voltage
CMOS Schmitt
Trigger
Vth
Vtl
1.8
1.0
2.8
2.0
3
Notes: 1) The host provides a logic output high voltage for a CMOS load of .9 x VCC. For a 5 volt product, this translates to .9 x
4.5 = 4.05 volts minimum Voh.
ꢁ
Output Drive Type
Note: In Table 3 below, x refers to the characteristics described in Table 4. For example, OT3 refers to Totem pole output with a type
3 output drive characteristic.
Table 3: Output Drive Type
Type
Output Type
Valid Conditions
Ioh & Iol
OTx
OZx
Totempole
Tri-State N-P Channel
Ioh & Iol
OPx
ONx
P-Channel Only
N-Channel Only
Ioh Only
Iol Only
Transcend Information Inc.
8
V1.0
TRANSCEND [ TRANSCEND INFORMATION. INC. ]
