TOKEN MEANS QUALITY AND SERVICE
Eectrical Characteristics
REQUIREMENTS
CHARACTERISTICS
TEST, METHOD (JIS C 5321)
Resistance to Soldering Heat
Solderability
No evidence of outer damage,
ꢀL/L shall be within Ř3%.
Immerse in the solder (H63A) of
260Ř5ꢁ for 10Ř1 sec, leave for
2hrs at normal TEMP.
Immerse in th solder (H63A) of
260Ř5ꢁ for 4Ř1 sec.
More than 90% surface to be
covered with new soldering.
Dielectric with standing voltage No evidence of damage
AV100V 60 SEC.
Insulation
No veidence of breakdown,
resistor 1000 mohm and over.
DC500V 30 SEC
Endurance Test
REQUIREMENTS
CHARACTERISTICS
TEST, METHOD (JIS C 5321)
LOW TEMP. Characteristics
No evidence of damage,
ꢀL/L within Ř5%,
ꢀQ/Q within Ř30%
Leave for 96Ř2hrs in a bath of
TEMP. -40Ř2ꢁ, measurements
shall be performed after 1~2hrs at
normal TEMP.
TEMP.Cycling
No evidence of damage,
ꢀL/L within Ř5%
Keep for 30 Min. at TEMP. of -25
ꢁ~+85ꢁ at 5 cycle case of
TEMP. Change from low to high
and V.V..
Temperature Characteristics
Moisture load Characteristics
ꢀL/L within Ř3%
ꢀL/L to be measured at the
temperature of between -25ꢁ
and + 85ꢁ
TEMP. -40Ř2ꢁ, Humidity
90~95% 96Ř2hrs, measurements
shall be performed after 1~2hrs at
normal TEMP..
No evidence of damage,
ꢀL/L within Ř5%,
ꢀQ/Q within Ř30%
High Temp. overload
Characteristics
No evidence of damage,
ꢀL/L within Ř5%,
ꢀQ/Q within Ř30%
Leave for 96Ř2hrs in a bath of
TEMP. -85Ř2ꢁ, measurements
shall be performed after 1~2hrs at
normal TEMP.
Phone:+886 2 29810109 Fax:+886 2 29887487 Email:token@token.com.tw http://www.token.com.tw
Page 7/12
TOKEN [ TOKEN ELECTRONICS INDUSTRY CO., LTD. ]
