78Q8392L/A03
Low Power Ethernet
Coaxial Transceiver
PIN DESCRIPTION
NAME
TYPE
DESCRIPTION
Collision Output. Balanced differential line driver outputs from the collision detect
circuitry. The 10 MHz signal from the internal oscillator is transferred to these
outputs in the event of collision, excessive transmission (jabber), or during CD
Heartbeat condition. These outputs are open emitters; pulldown resistors to VEE are
required. When operating into a 78Ω transmission line, these resistors should be
510Ω. In Cheapernet applications, where the 78Ω drop cable is not used, higher
resistor values (up to 1.5k) may be used to save power.
CD+*/CD-
O
Receive Output. Balanced differential line driver outputs from the Receiver. These
RX+*/RX-
TX+*/TX-
O
I
outputs also require 510Ω pulldown resistors.
Transmit Input. Balanced differential line receiver inputs to the Transmitter. The
common mode voltage for these inputs is determined internally and must not be
externally established. Signals meeting Transmitter squelch requirements are
waveshaped and output at TXO.
Heartbeat Enable. This input enables CD Heartbeat when grounded or left opened,
disables it when connected to VEE.
HBE
I
I
External Resistor. A fixed 976Ω 1% resistor connected between these pins
establishes internal operating currents.
RR+/RR-
Note: The previous generation 78Q8392L/A02 used a 1kΩ 1% resistor
Receive Input. Connects directly to the coaxial cable. Signals meeting Receiver
squelch requirements are equalized for inter-symbol distortion, amplified, and output
at RX+ and RX- pins.
RXI
I
TXO
CDS
GND
VEE
O
I
Transmit Output. Connects via an isolation diode to the coaxial cable.
Collision Detect Sense. Ground sense connection for the collision detect circuit. This
pin should be connected separately to the shield to avoid ground drops from altering
the receive mode collision threshold.
S
S
Positive Supply Pin.
Negative Supply Pins. These pins should be connected to a large metal frame area
on the PC board to handle heat dissipation, and bypassed to the GND pin with a
0.1µF capacitor as close to the package as possible.
*IEEE names for CD± = CI±, RX± = DI±, TX± = DO±
Notes: Pin type: I-input; O-output; S-power supply
Page: 4 of 14
© 2008 Teridian Semiconductor Corporation
Rev 1.3
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
