DS_8009R_056
73S8009R Data Sheet
Pin
Name
Pin
Pin
Type
Description
(SO28) (QFN20)
I/OUC
5
6
7
1
I/O
System controller data I/O to/from the card. Includes a pull-
up resistor to VDD.
AUX1UC
AUX2UC
NA
NA
I/O
I/O
System controller auxiliary data I/O to/from the card.
Includes a pull-up resistor to VDD.
System controller auxiliary data I/O to/from the card.
Includes a pull-up resistor to VDD.
CMDVCC%
CMDVCC#
8
9
2
3
I
I
Logic low on one or both of these pins will cause the LDO to
ramp the Vcc supply to the smart card and smart card
interface to the value described in the following table:
VCC Output Voltage
CMDVCC% CMDVCC#
0
0
1
1
0
1
0
1
1.8 V
5.0 V
3.0 V
LDO off
Refer to for additional information on the CMDVCC% and
CMDVCC# operation.
RSTIN
RDY
10
12
4
6
I
Reset Input. This signal is the reset command to the card.
O
Signal to controller indicating the 73S8009R is ready
because VCC is above the required value after CMDVCC%
and/or CMDVCC# is asserted low. A 20 KΩ pull-up resistor
to VDD is provided internally. The pull-up is disabled in
PWRDN and CS=0 modes.
PWRDN
13
7
I
PWRDN=1 puts the circuit into low-power mode with all
analog functions disabled. The circuit will recover from the
PWRDN state in the same manner as recovery from a POR
event, taking approximately 1 ms. PWRDN assertion when
either CMDVCC% or CMDVCC# is low has no effect and is
ignored. There is no pull-up or pull-down provided on this pin.
Rev. 1.3
7