SERIES A152
TYPICAL RF INSERTION LOSS REPEATABILITY CHARACTERISTICS (Notes 1 and 3)
A152 Insertion Loss Repeatability
(Through Path)
0.2
• Data represents 1 sample of A152-20-5
• Relay was cycled at 5 Hz and IL was measured at every 10K cycles
up to 1M cycles. Data presented is with respect to the first sweep.
• Relay was tested on a fixture made by Microtest Inc.
• HP 8719D VNA was used for measurements
• Test was performed at room temperature.
• RF input power level 10dBm
0.1
0
-0.1
0.0
0.3
0.6
0.9
1.2
1.5
1.8
2.1
2.4
2.7
3.0
3.3
3.6
3.9
4.2
4.5
4.8 5.0
Frequency (GHz)
A152 Insertion Loss Repeatability
(Attenuated Path)
1
0.9
0.8
0.7
0.6
0.5
0.4
0.3
0.2
0.1
0
• Data represents 1 sample of A152-20-5
• Relay was cycled at 5 Hz and IL was measured at every 10K cycles
up to 1M cycles. Data presented is with respect to the first sweep.
• Relay was tested on a fixture made by Microtest Inc.
• HP 8719D VNA was used for measurements
• Test was performed at room temperature.
• RF input power level 10dBm
-0.1
-0.2
0.0
0.3
0.6
0.9
1.2
1.5
1.8
2.1
2.4
2.7
3.0
3.3
3.6
3.9
4.2
4.5
4.8 5.0
Frequency (GHz)
RF INSERTION LOSS REPEATABILITY NOTES
1. Test conditions: a. Fixture: Custom plug-in test fixture.
b. Relay header is in contact with, but not soldered to, ground plane.
c. Test performed at room ambient temperature.
d. Contact signal level: 10 dBm.
2. Data presented herein represents typical characteristics and is not intended for use as specification limits.
3. Insertion loss repeatability measured over frequency range from 3 MHz to 5 GHz.
A152 Page 4
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
© 2006 TELEDYNE RELAYS
A152\042006\Q1
TELEDYNE [ TELEDYNE TECHNOLOGIES INCORPORATED ]
