SERIES 712
OUTLINE DIMENSIONS
SCHEMATIC DIAGRAM
TERMINAL LOCATIONS AND PIN NUMBERING (REF. ONLY)
(Viewed from Terminals)
CASE DETAIL
.370
(9.40)
DIA. MAX.
.031 (.79)
± .003 (0.08)
TRANSISTOR BASE
CONNECTION FOR
712TN ONLY
712
.335
(8.51)
DIA. MAX.
10
9
1
.035 (.89)
± .010 (0.25)
8
2
.275 (6.99) MAX.
3
7
.200 (5.08)
± .010 (.25) DIA.
4
6
5
36°±3°
TYP.
712D
712TN
WIRE LEAD: .75 (19.05) MIN.
SCHEMATICS ARE VIEWED FROM TERMINALS
DIMENSIONS ARE SHOWN IN INCHES (MILLIMETERS)
+.002 (.05)
–.001 (.03)
.017 (.43)
DIA.
TYPICAL LOGIC INTERFACE
(See Note 5)
GENERAL NOTES
1. Relay contacts will exhibit no chatter in excess of 10 µsec or transfer in excess of
1 µsec.
Vcc
Vr
Pin 1
2. “Typical” characteristics are based on available data and are best estimates. No
on-going verification tests are performed.
Notes:
Logic 1 activates the relay.
Logic 0 de-activates the relay.
Vcc = logic bias power.
Vr = coil energization voltage.
3. Unless otherwise specified, parameters are initial values.
4. For Reference Only. Coil resistance not directly measurable on 712TN relays.
5. Circuit is typical for all Series 712TN. Values shown are for 712TN-5 relay and
apply for full temperature range. Limit base-emitter current to 15 mADC
6. The slash and characters appearing after the slash are not marked on the relay.
7. Unless otherwise specified, relays will be supplied with either gold-plated or
solder-coated leads.
Logic element
Pin 10
1 = 0.50 to 3.00mA
0 = 0.3Vdc min.
Pin 9
8.
Teledyne Part Numbering System for Commercial Relays
712 M - 26 /
X
S
Q
Q= Solder Coated Leads
G= Gold Plated Leads
(Notes 6 and 7)
Relay Series
Optional Ground Pin
(See Appendix )
S= 0.187" leads
(Note 6)
Coil Voltage
Pad Option
(See Appendix)
712 Page 95
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
www.teledynerelays.com
©2009 TELEDYNE RELAYS
712/0909/Q3