PRELIMINARY INFORMATION
100mA ADJUSTABLE CMOS
LDO WITH SHUTDOWN
TC1071
ELECTRICAL CHARACTERISTICS: VIN = VOUT + 1V, IL = 0.1mA, CL = 3.3µF, SHDN > VIH, TA = 25
°C, unless otherwise noted.
Symbol
Parameter
Test Conditions
Min
Typ
Max
Units
ADJ Input
IADJ
Adjust Input Leakage Current
—
50
—
pA
NOTES: 1. VR is the regulator output voltage setting.
2. TC VOUT (VOUT VOUT
MIN) x 106
VOUT x ∆T
=
MAX –
3. Regulation is measured at a constant junction temperature using low duty cycle pulse testing. Load regulation is tested over a load
range from 0.1mA to the maximum specified output current. Changes in output voltage due to heating effects are covered by the
thermal regulation specification.
4. Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal value.
5. Ground pin current is the regulator pass transistor gate current. The total current drawn from the input supply is the sum of the load
current, ground current and supply current (i.e. IIN = ISUPPLY + IGND + ILOAD).
6. Thermal Regulation is defined as the change in output voltage at a time T after a change in power dissipation is applied, excluding load
or line regulation effects. Specifications are for a current pulse equal to ILMAX at VIN = 6V for T = 10msec.
7. The maximum allowable power dissipation is a function of ambient temperature, the maximum allowable junction temperature and the
thermal resistance from junction-to-air (i.e. TA, TJ, qJA). Exceeding the maximum allowable power dissipation causes the device to
initiate thermal shutdown. Please see Thermal Considerations section of this data sheet for more details.
PIN DESCRIPTION
Pin No.
(SOT-23A-5)
Symbol
Description
1
2
3
VIN
GND
SHDN
Unregulated supply input.
Ground terminal.
Shutdown control input. The regulator is fully enabled when a logic high is applied to this
input. The regulator enters shutdown when a logic low is applied to this input. During
shutdown, output voltage falls to zero and supply current is reduced to 0.05 microamp
(typical).
4
5
ADJ
Output voltage adjust terminal. Output voltage setting is programmed with a resistor divider
from VOUT to this input. A capacitor may also be added to this input to resuce output noise
(See Text).
VOUT
Regulated voltage output.
3
TC1071-01 6/13/97
TELCOM [ TELCOM SEMICONDUCTOR, INC ]
