M A P D CC0 0 0 7
Low Cost Four-wa y S M T P owe r
S p litte r/Com b in e r, 8 2 4 - 9 6 0 M H z
M /A -CO M P rod uc ts
R e v . 2
Electrical Specifications: TA = 25°C2
Parameter
Insertion Loss —above 6.0 dB theoretical loss“
Isolation
Frequency
Units
dB
Min
–
Typ
1.0
Max
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
1.2
–
dB
18
–
23
Input VSW R
Ratio
Ratio
dB
1.2:1
1.4:1
0.3
1.4:1
1.75:1
0.7
Output VSW R
–
Amplitude Balance
Phase Balance
–
Deg
–
2
4
2. All specifications apply with a 50-ohm source and load impedance.
Absolute Maximum Ratings 3,4
Parameter
Input Power 5
Absolute Maximum
1W CW
Recommended PCB Configuration
Operating Temperature
Storage Temperature
-40°C to +85°C
-65°C to +150°C
3. Exceeding any one or combination of these limits may cause
permanent damage to this device.
4. M/A-COM does not recommend sustained operation near
these survivability limits.
5. W ith internal load dissipation of 0.125W maximum.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM is considering for
development. Performance is based on target specifications, simulated results, and/or prototype
measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM has under develop-
ment. Performance is based on engineering tests. Specifications are typical. Mechanical outline has
been fixed. Engineering samples and/or test data may be available. Commitment to produce in
volume is not guaranteed.
• North America Tel: 800.366.2266 / Fax: 978.366.2266
• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300
• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298
Visit www.macom.com for additional data sheets and product information.
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or
information contained herein without notice.