M201/211 SERIES FREQUENCY MULTIPLIERS
ABSOLUTE MAXIMUM RATINGS
Operating Temperature Range -55°C to +125°C
ORDERING INFORMATION
PART NUMBER
M201P0622.08-032K
Specified Temperature Range
Select M201 for single-ended input
or M211 for differential input configuration.
M2X1X-XXXX.XX-XX X K
M2X1X-XXXX.XX-XX X L
M2X1X-XXXX.XX-XX X M
0°C to +70°C
-25°C to +85°C
-55°C to +125°C
Select device output format.
Specify "E" for ECL output format or "P"
for PECL output format
Storage Temperature Range -65°C to +150°C
Supply M201E
Supply M201P
Output Current
-7.0 to 0 Volts
0 to +7.0 Volts
50mA
Select device output frequency XXXX.XXMHz
Specify Multiplication Factor
32 or 33 or 64 or 65
Add "K" suffix for 0°C to +70°C operation
Add "L" suffix for -25°C to +85°C operation
Add "M" suffix for -25°C to +85°C operation
SPECIFICATIONS @ TA=+25°C, Vs= -5V for "E", Vs= +5V for "P" unless otherwise indicated
MIN.
TYP.
MAX
UNITS
Output Frequency
200
1
1000
MHz
%
Frequency Lock Range
Multiplication Factor
10
32
65
Input Impedance (Note 4)
450
500
550
Ohms
Input Voltage Levels: M201E
ECL, Single Ended
PECL, Single Ended
ECL Differential
M201P
M211E
M211P
PECL, Differential
Output Configuration (Note 1): M201/211E
M201/211P
Differential ECL
Differential PECL
Skew (Fout to Fref)
1.5
nsec
psec
Rise/Fall Time (20% to 80%)
Output Voltage Levels M201/211E
M201/211P
200
ECL Compatible
PECL Compatible
Output Drive (Note 1)
Output Symmetry (Note 3)
Output Phase Jitter (Note 2)
Start Up Time
50
mA
%
45/55
50/50
40
55/45
5
psec (rms)
msec
Power Supply Requirements:
M200211E (-VEE)
-4.50
-5.00
-5.25
Volts
Volts
M200/211P (+VCC)
+4.50
+5.00
+5.25
Power Supply Current:
M201/211E (-VEE)
-100
mA
mA
M201/211P (+VCC)
+100
Notes:
1. The output is measured with 250 Ohm termination resistor connected to V
2. The output jitter is measured with a maximum input jitter of 20psec p-p.
.
EE
3. Symmetry is measured at Vbb = -1.35V for M201/211E models and V bb = +1.35V for M201/211P models
4. The M211 model's input does not contain pulldown resistors thereby providing a high impedance to the differential
input source. The termination resistors should be located as close to the input pins as possible. The differential
input voltage should not exceed 1.0V.
micro networks324 Clark Street, Worcester, MA 01606-1293
Phone: (508) 852-5400; FAX (508) 853-8296
EMAIL: sales@mnc.com Web: http://www.mnc.com
v1.0 3/96
SPECTRUM [ SPECTRUM MICROWAVE, INC. ]
