M201/211 Series
Frequency Multipliers
Absolute Maximum Ratings
Ordering Information
Operating Temperature Range
-55°C to +125°C
Part Number
M201P-0622.08-32K
Specified Temperature Range
M2X1X-XXXX.XX-XX K
M2X1X-XXXX.XX-XX L
M2X1X-XXXX.XX-XX M
Select M201 for single-ended input
or M211 for differential input configuration
0°C to +70°C
Select device output format
Specify “E” for ECL output format or “P”
for PECL output format
-25°C to +85°C
-55°C to +125°C
Select device output frequency XXXX.XXMHz
Storage Temperature Range
-55°C to +125°C
Specify Multiplication Factor
32 or 33 or 64 or 65
Supply M201/211E
Supply M201/211P
Output Current
-7.0 to 0 Volts
0 to + 7.0 Volts
50mA
Add “K” suffix for 0°C to +70°C operation
Add “L” suffix for -25°C to +85°C operation
Add “M” suffix for -55°C to +125°C operation
Specifications
Specifications @ TA= +25°C, -VEE = -5V for “E”, +VCC = +5V for “P”, unless otherwise indicated
Min.
Typ.
Max.
Units
200
1
32
1000
MHz
%
Output Frequency Range
Frequency Lock Range
Multiplication Factor
10
65
450
500
550
Ohms
Input Impedence (Note 4)
ECL, Single Ended
PECL, Single Ended
ECL, Differential
Input Voltage Levels: M201E
M201P
M211E
M211P
PEC, Differential
Output Configuration (Note 1):
Differential ECL
Differential PECL
M201/211E
M201/211P
1.5
200
nsec
psec
Skew (Fout to Fref)
Rise/Fall Time (20% to 80%)
Output Voltage Levels: M201/211E
M201/211P
ECL Compatible
PECL Compatible
50
55/45
5
mA
%
psec (rms)
msec
Output Drive (Note 1)
45/55
50/50
40
Output Symetry (Note 3)
Output Phase Jitter (Note 2)
Start Up Time
Power Supply Requirements:
M200/211E (-VEE)
-4.50
+4.50
-5.00
+5.00
-5.25
+5.25
Volts
Volts
M200/211P (+VCC
)
Power Supply Current:
M201/211E (-VEE)
-100
+100
mA
mA
M201/211P (+VCC
)
Notes: 1. The output is measured with 150 Ohm termination resistor connected to VEE
2. The output jitter is measured with a maximum input jitter of 20psec p-p.
.
3. Symmetry is measured at VBB = -1.35V for M200/210E models and VBB = +VCC -1.35V for M200/210P models.
4. The M211 model’s input does not contain pulldown resistors thereby providing a high impedance to the differential input source.
The termination resistors should be located as close to the input pins as possible.The differential input voltage should not exceed 1.0V.
324 Clark St., Worcester, MA 01606
Tel. (508) 852-5400 • FAX (508) 853-8296
E-Mail – sales@mnc.com
Web Site – http://www.mnc.com
SPECTRUM [ SPECTRUM MICROWAVE, INC. ]
