AS2810
Basic Adjustable Regulator
VIN
VOUT
AS2810
VIN
5V
VREF
VOUT
3.3V
R1
R2
AS2810
IADJ
50µA
C2
10uF
C1
10uF
VOUT = VREF * ( 1 + R/R1) + IADJ * R2
2
Basic Fixed Regulator
Fig.2 Basic Adjustable Regulator
Output Voltage
Consider Figure 2. The resistance R1 generates a constant
current flow, normally the specified load current of 10mA.
This current will go through the resistance R2 to set the overall
output voltage. The current IADJ is very small and constant.
Therefore its contribution to the overall output voltage is very
small and can generally be ignored.
Output Voltage
The fixed voltage LDO voltage regulator are simple to use
regulators since the VOUT is preset to the specifications. It is
important however, to provide the proper output capacitance
for stability and improvement. For most operating conditions
a capacitance of 22uF tantalum or 100uF electrolytic will
ensure stability and prevent oscillation.
Load Regulation
Parasitic line resistance can degrade load regulation. In order
not to affect the behavior of the regulator, it is best to connect
directly the R1 resistance from the resistor divider to the case,
and not to the load. For the same reason, it is best to connect
the resistor R2 to the Negative side of the load.
RP Parasitic Line
Resistance
VIN
AS2810
Connect R 1 to
Case of Regulator
R1
RL
R2
Connect R 2 to Load
Fig.3 Basic Adjustable Regulator
Rev. 10/2/00
SIPEX [ SIPEX CORPORATION ]
