EZRadioPRO-DK
3. Hardware Setup
After checking the kit contents against Tables 2 and 3, the kit can be put into operation by performing the steps
listed below.
Figure 1. Wireless Motherboard Top Markings
1. Insert an RF Pico board into the connectors labeled as CON1 and CON2 on the Wireless Motherboard
(WMB).
2. Insert a UPPI-930-RF MCU Pico Board into the connectors, J5, J6, J7, and J8, on the WMB. The dotted
corner of the F930 MCU has to point to the triangle symbol on the WMB.
3. Connect the antenna to the SMA connector on the RF Pico Board.
4. Set the SUPPLY SELECT switch to the USB position.
5. Set the MCU DC/DC switch to the OFF position.
6. Ensure that all the CURRENT MEASUREMENT jumpers are in place.
7. Start the WDS on your PC.
8. Using one of the USB cables in the kit, connect the WMB to the PC.
9. If necessary wait for Windows to install the debug interface driver.
10. WDS must identify the connected board and open an Application Manager window that lists information
about the identified board.
11. Boards are shipped without preloaded software. Sample codes can be configured and downloaded to the
MCU from WDS. For details on how to use the WDS, see the WDS User's Guides listed in "4. Useful
Documentation" on page 5".
Rev. 0.5
3
SILICON [ SILICON ]
