Si477x-EVB
3. Quick-Start Guide
This section gives three quick steps to get your evaluation kit installed and running. Refer to the following sections
for additional details on configuring and using the kit.
3.1. Install the Software
Insert the CD.
Open the file Start_Here.htm.
Click on the link to the GUI.
Run setup.exe.
3.2. Connect the Board
Configure the PCB for USB as the power source:
Slide switch to "USB".
Place four jumpers between "LDO" and "TNR" positions.
Figure 2. Selecting USB Power Source
Connect headphones or powered speakers to the HEADPHONE_OUT jack.
Figure 3. Audio Output Connection
4
Rev. 0.3