F10067 Series
Page 1 of 4
RTI AUDIO FILM CAPACITORS
F10067 Series - 200VDC
Metallized Polypropylene
MATERIAL:
Metallized Polypropylene capacitors in non-inductive construction.
LEADS:
Tinned Copper soldered to capacitor with 63-37 Sn-Pb
TEMPERATURE RANGE:
May be operated at rated voltage from -55°C to + 85°C. Voltage must be de-
rated linearly to 60% between +85°C to +105°C.
ELECTRICAL [NON-DESTRUCTIVE] TESTS:
1.
Capacitance shall be measured at 1 KHz. ± 20 Hz and + 25°C for values up to 1.0 MFD. Values
greater than 1.0 MFD. shall be measured at 120 Hz. ± 10 Hz.
Ref: MIL-STD-202E, method 305.
2.
Dissipation Factor shall be measured as described for capacitance and shall not exceed 0.2%.
3.
Insulation Resistance shall be measured at rated voltage. After 2 minutes under voltage, minimum
values shall be 200,000 MEG/MFD., need not exceed 400,000 megohms.
Ref: MIL-STD-202E, method 302.
4.
Dielectric Strength: Capacitors shall withstand specified DC test potential for 60 seconds through a
limiting resistance of 1 ohm/volt. Terminal to terminal will be 150% of rated voltage. TerminaI to
case will be 200 % of rated voltage..
Ref: MIL-STD-202E, method 301.
5.
Dielectric Absorption shall not exceed 0.1% when tested to MIL-C-19978D.
Ref: MIL-C-19978D, paragraph 3.22.
TYPICAL TEMPERATURE CHARACTERISTICS
RHOPOINT COMPONENTS LTD
Tel: +44 (0) 870 608 1188 Fax: +44 (0) 870 241 2255
RHOPOINT [ RHOPOINT COMPONENTS ]
