FIRETRAP
Check the Wiring required for your Trap:
The FIRETRAP is capable of switching nearly any trap type, however wiring convenꢀons vary between
manufacturers. The relays on the FIRETRAP can switch up to 24V DC or 230V AC @ 5A.
Addiꢀonal Transmiꢁers
Each transmiꢁer has a unique idenꢀty. Each ꢀme a transmiꢁer switch is operated, it transmits a secure
RF signal. The Receiver can to set learn this signal and pair it to any of its outputs.
To pair a New Transmiꢁer switch follow this procedure:
Any transmiꢁer buꢁon can be paired to one or many of the receiver output relays.
Each buꢁon must be paired to each relay individually by following this procedure:
Select the receiver output relay to pair:
1.
2.
3.
Briefly press the receiver pairing switch (S2) once.
The Receiver pairing LED will flash once to indicate output relay 1 is selected.
Aꢂer the Receiver pairing LED stops flashing, press the receiver pairing switch again to select the
next relay.
4.
5.
6.
Repeat step 2 unꢀl the required output relay is selected.
Press the buꢁon on the transmiꢁer you want to pair to the selected relay.
The receiver pairing LED will Flash once to confirm pairing is complete.
Erasing Receivers Memory
Press and hold the receiver pairing switch for approx 10 seconds.
Release the switch and watch for the receiver LED to flash to confirm erasing.
Press a buꢁon on the transmiꢁer and ensure no relay acꢀves
NOTE: You cannot erase individual transmiꢁers or buꢁons
Configuring Receiver Relays
The link caps (shown above) configure the outputs operaꢀon. The these links are connected/broken us-
ing the small link cap placed over the pins. To “store” the seꢃng turn power off then back on.
Link Posiꢀons
Relay Outputs
LK1
LK2
RLY 1
RLY 2
RLY 3
RLY 4
Open
Closed
Open
Open
Open
Closed
1/2 sec Mom
1/2 sec Mom
Mom
1/2 sec Mom
Mom
1/2 sec Mom
Mom
1/2 sec Mom
Mom
Mom
Mom
Mom
Closed
Closed
-
-
-
-
RFSOLUTIONS [ RFSOLUTIONS.LTD ]
