‘001’SERIES RADIO RECEIVER DECODER MODULES.
Pin Description
Pin No
Name
+12V
0 VOLT
+5V
0 VOLT
O/P1
Description
+12V Supply Voltage. Must be used for Relay operation
Ground for +12V Supply.
+5V Supply Voltage. Alternative supply if 12v supply not used. See Note
Ground for +5V Supply. See Note
1
2
3
4
8
Data output channel 1. Open collector Transistor output.
(This is used to drive the relay when fitted)
9
O/P2
O/P3
O/P4
LINK2
LINK2
LINK1
LINK1
+ve LED
Data output channel 2. CMOS/TTL with series 220 W resistor
Data output channel 3. CMOS/TTL with series 220 W resistor
Data output channel 4. CMOS/TTL with series 220 W resistor
Connect to pin 13 to make “Link2”
Connect to pin 12 to make “Link2”
Connect to pin 15 to make “Link1”
Connect to pin 14 to make “Link1”
External LED sink output, can be connected directly to cathode of external LED.
Connect Anode of the LED to +5V.
10
11
12
13
14
15
16
Indicates Data reception, and programming status.
Programming Switch, This is used when learning new transmitters.
Not connected. Can be used as locating pin for mounting the module
Connect to 17 to make “PSW1” switch.
Not connected. Can be used as locating pin for mounting the module
Connect Antenna to this input
17
18
19
20
21
PSW1
N/C
PSW1
N/C
ANT I/P
The module uses these pins when configured as FM.
Not connected. Can be used as locating pin for mounting the module
The module uses these pins when configured as AM.
Not connected. Can be used as locating pin for mounting the module
The module uses these pins when configured as AM.
Not connected. Can be used as locating pin for mounting the module
The module uses these pins when configured as AM.
These pins are used when configured as an AM or FM module.
Relay contacts Normally Open
22 - 23
24 - 25
26 - 28
29 - 31
32
33 - 34
35
36 - 40
P4/1
P4/2
P4/3
N/C
N/C
N/C
P4/1
P4/2
P4/3
Relay contacts Common
Relay contacts Normally Closed
NOTE:
The module is designed to be powered from either 12v or 5v not both!
The 12v supply is necessary for relay operation.
AM Transmitter Keyfob Switch / Output Table
O/P 1
O/P 2
-
RH Switch
RH Switch
O/P 3
1 Switch Keyfob
2 Switch Keyfob
3 Switch Keyfob
Centre Switch
LH Switch
LH Switch
-
-
Top Switch (Red)
Link Status
Link1
Open
Open
Link2
Open
Connected
Open
O/P 1
O/P 2
Latch
Mom
Mom
Latch
O/P 3
Latch
Mom
Latch
Mom
O/P 4
Latch
Mom
Latch
Mom
Latch
Mom
Mom
Latch
Connected
Connected
Connected
DS101-4 Aug ‘02
Ó2002 Reg. No. 277 4001, England.
Page 3
RFSOLUTIONS [ RFSOLUTIONS.LTD ]
