Preliminary
SF2220C
•
•
•
•
•
Low Insertion Loss
Excellent Size-to-performance Ratio
Hermetic SM5050-8 Surface-mount Case
Single-ended Input and Output
Complies with Directive 2002/95/EC (RoHS)
Pb
Value
+18
30
-40 to +85
193.60 MHz
SAW Filter
Units
dBm
VDC
°C
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage on any Non-ground Terminal
Storage Temperature Range in Tape and Reel
Suitable for Lead-free Soldering - Maximum Soldering Profile
260 °C for 30 s
SM5050-8
Electrical Specifications
Characteristic
Nominal Center Frequency
Passband:
Minimum Insertion Loss
3 dB Bandwidth
Amplitude Ripple , 193.56 to 193.64 MHz
Group Delay Variation, 193.545 to 193.655 MHz
Absolute Delay at 193.6 MHz
Rejection:
193.49 and 193.71 MHz
30 dB Low Side Rejection Frequency
30 dB High Side Rejection Frequency
Ultimate Rejection, <192.2 MHz, >195.0 MHz
Operating Temperature Range
T
A
1
45
0
1, 2, 3
10
TBD
15
193.432
193.753
50
+70
TBD
dB
MHz
dB
°C
GDV
AGD
5100
BW
3
1, 2
110
Sym
f
C
Notes
1
Min
Typ
193.60
5.0
145
0.5
2100
5400
Max
Units
MHz
7.0
1.0
2500
5700
dB
kHz
dB
P-P
ns
P-P
ns
Impedance Matching to 50
Ω
Single-ended Source and Load
Case Style
Lid Symbolization (YY = year, WW = week)
External L-C
SM5050-8, 5 x 5 mm Nominal Footprint
957, YYWW
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
4.
5.
6.
7.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with
impedance matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for details.
The turnover temperature, T
O
, is the temperature of maximum (or turnover) frequency, f
o
. The nominal frequency at any case temperature, T
c
, may
be calculated from: f=f
o
[1-FTC(T
o
-T
c
)
2
].
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port
1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
www.RFM.com E-mail: info@rfm.com
©2010 by RF Monolithics, Inc.
Page 1 of 4
SF2220C - 9/22/10
RFM [ RF MONOLITHICS, INC ]
