SF2089C
• Low Insertion Loss
• 5.0 X 5.0 mm Surface-mount Case
• Single-ended Input and Output
• Complies with Directive 2002/95/EC (RoHS)
327.5 MHz
SAW Filter
Pb
Absolute Maximum Ratings
Rating
Value
+13
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Maximum DC Voltage on any Non-ground Terminal
Storage Temperature Range in Tape and Reel
30
-40 to +85
Suitable for Lead-free Soldering - Maximum Soldering Temperature
260 °C for 30 s
SM5050-8
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss
Sym
Notes
Min
Typ
327.5
Max
Units
MHz
dB
f
1
C
1
12
1.5 dB Bandwidth
BW
1
35
MHz
1.5
Amplitude Ripple, f ±17.5 MHz, within adjacent 5 MHz windows
1
1
50
dB
C
P-P
P-P
P-P
Group Delay Deviation, f ±17.5 MHz, within adjacent 5 MHz windows
1
ns
ns
C
Group Delay Deviation, f ±17.5 MHz, full bandwidth
1
50
100
2.5:1
65
C
VSWR at f
1
C
40 dB Rejection Bandwidth
Operating Temperature Range
Case Style
1, 2
MHz
°C
-40
85
SM5050-8 5 x 5 mm Nominal Footprint
RFM 591 YWWS
Lid Symbolization (Y=year, WW=week, S=shift)
Electrical Connections
Connection
Terminals
Port 1
Port 2
Input
1
5
Output
Ground
All others
Dot indicates Pin 1
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
3.
4.
5.
The design, manufacturing process, and specifications of this filter are subject to change.
Tape and Reel Standard ANSI / EIA 481.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
6.
7.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: info@rfm.com
©2009-2010 by RF Monolithics, Inc.
Page 1 of 6
SF2089C - 6/14/10
RFM [ RF MONOLITHICS, INC ]
