®
SF2027B
•
•
•
GSM BTS Receiver IF Applications
Small Size
Hermetic 13.3 X 6.5 mm Surface Mount Case
199.0 MHz
SAW Filter
Input power Level short test
+18 dBm
+10 dBm
10V
standard operation, max
Max DC Voltage between any 2 terminals
Input: possible for balanced and unbalanced operation (TBD)
Output: Balanced
SMP-53-S
External matching to 50 or 200 ohms
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
f
1
Nominal Frequency
199.0
< 7.0
< 700
< 1.0
< 0.7
> 10
MHz
dB
N
Insertion Loss
(including matching to 200 ohms)
(198.9 .. 199.1 MHz)
IL
ns
Group Delay Ripple, peak - peak
Amplitude Ripple, peak - peak
(198.9 .. 199.1 MHz)
dB
Relative attenuation
fn - 100 kHz .. fn +100 kHz (passband)
fn - 300 kHz, fn +300 kHz
fn - 500 kHz, fn +500 kHz
fn - 600 kHz, fn +600 kHz
<fn - 700 kHz,> fn +700 kHz
dB
dB
dB
dB
> 27
> 36
> 45
Case Style
SMP-53-S 13.3 X 6.5 mm Nominal Footprint
RFM SF2027B YWWS
Lid Symbolization (Y=year, WW=week, S=shift) See note 4
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature
5.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1 and
Port 2, so that the filter must always be installed in one direction per the circuit
design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of
RF Monolithics, Inc.
range with filter soldered to the specified demonstration board with impedance
matching to 50 W and measured with 50 W network analyzer. A dB offset exists
for RFM because of the loss introduced by using transformers on the Input and
Output.
Rejection is measured as attenuation below the minimum IL point in the pass-
band. Rejection in final user application is dependent on PCB layout and exter-
nal impedance matching design. See Application Note No. 42 for details.
"LRIP" or "L" after the part number indicates "low rate initial production" and
"ENG" or "E" indicates "engineering prototypes."
6.
7.
2.
8.
9.
©Copyright 1999, RF Monolithics Inc.
Electrostatic Sensitive Device. Observe precautions for handling.
3.
4.
The design, manufacturing process, and specifications of this filter are subject
to change.
RF Monolithics, Inc.
RFM Europe
Phone: (972) 233-2903
Phone: 44 1963 251383
Fax: (972) 387-8148
Fax: 44 1963 251510
E-mail: info@rfm.com
http://www.rfm.com
SF2027B-041403
Page 1 of 4
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
RFM [ RF MONOLITHICS, INC ]
