LNK353/354
Conditions
SOURCE = 0 V; TJ = -40 to 125 °C
See Figure 7
Parameter
Symbol
Min
Typ
Max
Units
(Unless Otherwise Specified)
OUTPUT (cont)
DRAIN Supply
Voltage
50
V
µs
µs
ms
%
Output Enable
Delay
tEN
See Figure 9
10
Output Disable
Setup Time
tDST
0.5
31
5
Auto-Restart
ON-Time
TJ = 25 °C
See Note H
tAR
Auto-Restart Duty
Cycle
DCAR
NOTES:
A. Total current consumption is the sum of IS1 and IDSS when FEEDBACK pin voltage is ≥2 V (MOSFET not
switching) and the sum of IS2 and IDSS when FEEDBACK pin is shorted to SOURCE (MOSFET switching).
B Since the output MOSFET is switching, it is difficult to isolate the switching current from the supply current at the
DRAIN. An alternative is to measure the BYPASS pin current at 6 V.
C. See Typical Performance Characteristics section Figure 14 for BYPASS pin start-up charging waveform.
D. This current is only intended to supply an optional optocoupler connected between the BYPASS and FEEDBACK
pins and not any other external circuitry.
E. For current limit at other di/dt values, refer to Figure 13.
F. This parameter is guaranteed by design.
G. This parameter is derived from characterization.
H. Auto-restart on time has the same temperature characteristics as the oscillator (inversely proportional to
frequency).
F
2/05
9
POWERINT [ Power Integrations ]
