Model 4488, BNC (M)
Compression Style Connector
& Assembly Instructions
1:
Style A
2:
3:
4:
(a)
(b)
5:
6:
(a)
(a)
(b)
(b)
(c)
Assembly Instructions
1. Verify all parts are present.
2. (a) Cut outer jacket and shield 5/16” (7,94mm) from cable end to the depth of the dielectric. Remove
outer insulation and coax shield. (b) Cut 3/16” (4,76mm) from the cable end to the depth of the center
conductor and remove dielectric exposing center conductor.
3. Slide center pin contact onto center conductor, all the way against the dielectric. Solder or crimp to
center contact.
4. Slide clamp nut, washer and gasket on to coax cable.
5. (a) Slide ferrule over dielectric and under the coax braided shield. (b) Verify that ferrule is pushed up
against outer jacket .
Al6l d.ime(nas)ionPsuarsehinainscsheesm. Tbolleyranincetso(exbcoepdtynoutedn)t:i.lxxc=e±n.0te2”r(c,5o1nmtma)c, t.xx“xs=na±p.0s0”5”i(n,1t2o7 mbmo)d. y. (b) Slide clamp nut, washer, gasket
All specfifoicrawtioansrdar.e to(cth)eUlatseset r7ev/i1si6on”s.(S1pe1cmificmati)onws arreensucbhjecot tno cthhaengebwoidthyouat nnodticce.lamp nut, tighten to 18 – 22 in-lbs.
Registered trademarks are the property of their respective companies.
Sales: 800-490-2361 Fax: 888-403-3360 Technical Support: 800-241-2060 (technicalsupport@pomonatest.com)
For “Where to Buy” information, visit the Pomona web site at www.pomonaelectronics.com
Rev: 100
D1094174
Page 2 of
3