CUSTOMER DRAWING
TABLE 1
REQUIREMENTS FOR MOLDED COMPONENT
Property
Tensile Strength
Unit
Requirement
1500 minimum
Method of Test
Section 4.3.1
psi
Ultimate Elongation
Stiffness
percent
psi
250 minimum
10,000 minimum
25,000 maximum
1.40 maximum
50±10
(ASTM D 412)
ASTM D 747
Specific Gravity
Hardness
ASTM D 792
ASTM D 2240
Section 4.3.2
Shore D
Low Temperature Flexibility
4 hours @ -55°C (-67°F)
Heat Shock
4 hours @ 225°C (437°F)
Heat Aging
No cracking
No Dripping, flowing or
cracking
Section 4.3.3
Section 4.3.4
Procedures A and B
Followed by test for:
Tensile Strength
Ultimate Elongation
psi
percent
1200 minimum
200 minimum
Non-burning
Rating of 1 or less
0.2 maximum
Section 4.3.1
(ASTM D 412)
ASTM D 635
ASTM D 876
ASTM D 570
Procedure A
Section 4.3.5
Flammability
Fungus Resistance
Water Absorption
24 hours @ 25° C (77°F)
Solvent Resistance
24 hours @ 25°C (77°F) in
JP-4 Fuel
percent
Skydrol* 500
Hydraulic Fluid (MIL-H-5606)
Aviation Gasoline (100/130)
Water
Followed by test for:
Tensile Strength
Ultimate Elongation
psi
percent
1200 minimum
200 minimum
Section 4.3.1
(ASTM D 412)
Tyco Electronics
TITLE:
305 Constitution Dr
Menlo Park, CA
94025, U.S.A.
CAP, SPLICE ENCAPSULATION
DOCUMENT NO.:
Unless otherwise specified dimensions are in millimeters.
[Inches dimensions are shown in brackets]
Raychem
Devices
D-300-08/-12/-18
TOLERANCES:
0.00 N/A
0.0 N/A
ANGLES: N/A
Tyco Electronics reserves the right to
amend this drawing at any time. Users
should evaluate the suitability of the
product for their application.
REV:
DATE:
ROUGHNESS
IN MICRON
B
31-July-08
0 N/A
DRAWN BY:
CAGE CODE:
REPLACES:
ECO NUMBER:
SCALE:
SIZE:
SHEET:
M. FORONDA
06090
D010044
08-018889
NTS
A
5 of 7
© 2008 Tyco Electronics Corporation. All rights reserved
If this document is printed it becomes uncontrolled. Check for the latest revision.
PANDUIT [ PANDUIT CORP. ]
